[FlatheadTed]

Ok fire away .I am thinking of just going to pictures might be easer (1) remove the front wheels and hubs attached (front ) or all four ,remove the shoes ,screw the top adjuster in until you push out the dust cap and bolt that's on the inner backing plate ,remove the lower Anchor bolt and washer ( the nut is below the king pin on the out side )take the new anchor bolt and place your old slotted wedge over it (check this wedge for any excessive grooves were the rollers go ),then the black stamping plate flat side down curved side up ,fit these back into your backing plate a little over finger tight ,Fit the upper new adjuster bolt but first run the thread cleaner grub screw through the hole ,remove the rollers from your shoes lower end ,replace them with the new pins and one of your rollers facing out ,shoes should be kept in the same location check them for ware and lining type must be a soft material ,rollers should be firm and not wobble about also the adjuster link the same .go as far as you can and ask ,let us know ,Ted