The Ford Barn - View Single Post

donald1950 · 11-13-2017, 05:20 PM

i have 4 car ramps that i run the car up on and chain down all 4 tires to them and a transmission jack from Harbor Freight to get it up and down. i use 4 bolts (heads cut off) about 6 inches long with a about a 1/2 inch of slight taper and screwdriver slots cut into them to remove them. they are long enough that the transmission in on the bolts just before the input shaft enters the bell housing. having 4 "dowel pins" really helps center and guide the input shaft to the poilet bearing and the transmission jack keeps the transmission very level for the slide home....

11-13-2017, 05:20 PM	#4
donald1950 Senior Member Join Date: May 2010 Location: san antonio, texas Posts: 461	Re: Overdrive fixed!!! i have 4 car ramps that i run the car up on and chain down all 4 tires to them and a transmission jack from Harbor Freight to get it up and down. i use 4 bolts (heads cut off) about 6 inches long with a about a 1/2 inch of slight taper and screwdriver slots cut into them to remove them. they are long enough that the transmission in on the bolts just before the input shaft enters the bell housing. having 4 "dowel pins" really helps center and guide the input shaft to the poilet bearing and the transmission jack keeps the transmission very level for the slide home....