The Ford Barn - View Single Post

TagMan · 03-05-2017, 01:38 PM

I'll try and get a picture of it, but as I recall, there were (2) wooden blocks, one in each side, of that channel and a long bolt went through the floor pan (behind the side supports in the trunk area) and through the wooden block and were secured with a hex nut. The (2) bolts acted as a body mounting bolt.

There was not a single, long piece of wood from one side to the other.

This was on my '36 3W.

-Bob

03-05-2017, 01:38 PM	#4
TagMan Senior Member Join Date: Jul 2011 Location: Alvaton, Kentucky, USA Posts: 962	Re: 35/36 rear floor cross member I'll try and get a picture of it, but as I recall, there were (2) wooden blocks, one in each side, of that channel and a long bolt went through the floor pan (behind the side supports in the trunk area) and through the wooden block and were secured with a hex nut. The (2) bolts acted as a body mounting bolt. There was not a single, long piece of wood from one side to the other. This was on my '36 3W. -Bob