Re: Flathead filter
Guys, I was reading through the posts on this and had a question. My original 41 24 stud has a filter mounted on the left head. There is a line coming from the block where the oil pressure sensor unit, going to the filter and from there it goes to the front of the engine. The line has a fitting at that end that accepts one of the bolts that hold the timing cover on. That bolt has in it allowing the oil to return near the cam gears.
I moved this system to the new engine. The new engine is the same except there is a T fitting where the pressure sensor and oil line are attached. My oil psi is around 60 to 80 depending on temp.
If I take the filter system off and plug that line I am guessing I will have more psi correct?
Or if I reduce the line size at one end by welding it up and drilling a .060 hole.
Now I learned that I get a pretty good flow of oil out of this line now but I worry about ruining my new engine. Any thoughts? I have about 250 miles on it now.
Mark
|