The Ford Barn - View Single Post - 1932 Roadster

woodiewagon46 · 12-01-2016, 03:38 PM

Glenn, If you keep the hinge higher than you should won't you raise the rear of the hood. Why not trim the rubber to allow the hinge bracket to sit where it should? Also even if you do try to lower it, will the hinge mount clear the two stampings on ether side? I would make it fit like Charlies.

12-01-2016, 03:38 PM	#7
woodiewagon46 BANNED Join Date: Jun 2012 Location: Long Island,NY Posts: 1,568	Re: 1932 Roadster - Rear Hood Hinge Bracket? Glenn, If you keep the hinge higher than you should won't you raise the rear of the hood. Why not trim the rubber to allow the hinge bracket to sit where it should? Also even if you do try to lower it, will the hinge mount clear the two stampings on ether side? I would make it fit like Charlies.