The Ford Barn - View Single Post

Marvin/TN · 10-19-2016, 02:23 AM

To keep from lifting the stripe gently pull the tape at low angle away and back. I use model car paint and use regular masking tape. Tape the car completely, cut the tape at each panel, use a striping brush, do one panel at a time, pull off the tape as soon as you stripe a panel before going to the next panel. Doing it that way the paint will flow and not leave a rough edge. Practice a little on something and you will see how it works.

10-19-2016, 02:23 AM	#7
Marvin/TN Senior Member Join Date: May 2010 Location: Chattanooga, TN area Posts: 832	Re: How I pinstriped my 33 Tudor To keep from lifting the stripe gently pull the tape at low angle away and back. I use model car paint and use regular masking tape. Tape the car completely, cut the tape at each panel, use a striping brush, do one panel at a time, pull off the tape as soon as you stripe a panel before going to the next panel. Doing it that way the paint will flow and not leave a rough edge. Practice a little on something and you will see how it works.