The Ford Barn - View Single Post

Ole Don · 08-30-2016, 09:32 AM

The new one you have will work fine. Oil it up before you put it on, tighten by hand as far as it will go, then about 1/2 to one turn after that. The rubber will squeeze in and out because of the taper on the nut and the oil pump.

08-30-2016, 09:32 AM	#5
Ole Don Senior Member Join Date: May 2010 Location: St. Michael, Minnesota Posts: 1,713	Re: Oil pan tube to oil pump seal The new one you have will work fine. Oil it up before you put it on, tighten by hand as far as it will go, then about 1/2 to one turn after that. The rubber will squeeze in and out because of the taper on the nut and the oil pump.