[tof33]

The custom made inner ring is very simple:

in diameter : depends your housing surface, but usually the original bearing surface
out diameter : the inner diameter of the IKO bearing : 55mm
length : the original bearing surface housing length

Precision:
- you need 2 IKO inner bearing : one for the bearing and a half for the seal.
- and another part to turn whick hold the seal (62X72X9 metric size : I'm a frenchy :-) )

About the cost : 120 Eur for bearing, ring and seal, 100Eur for truning custom ring and seal support + Loctite.
So a repair for 250 Eur.


I haven't take other picture because of time lack : I have to use the car for a meeting.