The Ford Barn - View Single Post

BN · 07-14-2016, 07:13 PM

I order a new nu-Rex "looks like pop out but isn't" ignition switch about 3 months ago. I tested it for continuity when it arrived, and there was no continuity between the two terminals when in the "on" position. The supplier sent me another one. It did have continuity, so I installed it. The other day my "A" wouldn't start. No voltage at the cable that screws into the distributor. Pulled the dash out again and checked the continuity of the switch. No continuity in the "on" position. What's going on here? Has no-Rex cut their quality to the bone?

07-14-2016, 07:13 PM	#22
BN Senior Member Join Date: Jul 2010 Location: Keller, Tx Posts: 114	Re: Ignition switch I order a new nu-Rex "looks like pop out but isn't" ignition switch about 3 months ago. I tested it for continuity when it arrived, and there was no continuity between the two terminals when in the "on" position. The supplier sent me another one. It did have continuity, so I installed it. The other day my "A" wouldn't start. No voltage at the cable that screws into the distributor. Pulled the dash out again and checked the continuity of the switch. No continuity in the "on" position. What's going on here? Has no-Rex cut their quality to the bone? __________________ Bill Newland