[GB SISSON]

The sun shone bright all day and I am almost caught up with the rush in my cabinet work so took a day off to work on the woodie. My engine work is stalled for a technical glitch so I decided to start mocking up doors. The rear doors are more simple so I started there. I have been using panel truck doors to set the curves and angles because they match the truck's roof line and I think it is the way to carry the belt line back aft for something that started as a truck. I learned a tremendous amount today in mocking up this door with scrap lumber. Good thing, as my supply of expensive Eastern maple won't last forever. It is quite humbling to do a bunch of math and measuring only to have the first attempt not line up with the back half and the front hinge. I reverted to a straight board, hell with the math and got a nice fair line down the length of the body. Now to copy this in hard maple and get the front doors to follow suit. All the doors I build will be a bit oversized so I can do a final fitting when the engine and transmission are buttoned up. It's a pretty gol dang fun project I gotta say.....