The Ford Barn - View Single Post

Fred A · 03-10-2016, 07:28 PM

The Brookville dashrail is sorta OK. The ends need a little hammer fitting and the captured nuts that hold the tank are the wrong size, reduced to 1/4", originally 5/16". The bottom edge of the rail is not notched for the later column support. Use your original as a pattern. Good Luck: Fred A

03-10-2016, 07:28 PM	#2
Fred A Senior Member Join Date: May 2010 Location: Encino California, near Burbank Posts: 945	Re: '31 Roadster dash rail The Brookville dashrail is sorta OK. The ends need a little hammer fitting and the captured nuts that hold the tank are the wrong size, reduced to 1/4", originally 5/16". The bottom edge of the rail is not notched for the later column support. Use your original as a pattern. Good Luck: Fred A