The Ford Barn - View Single Post - here we go again... does anyone make 3 7/8

scooder · 11-20-2015, 08:20 PM

Chris,
There's a lot of Ford pistons out there with 5/16" from the crown edge to top of first ring. These won't reach the top with an 1/8" stroke. Also all the OEM Ford pistons have the crown edge quite a bit lower than the deck. These both make the use of them with the 1/8" stroke ideal.
Martin.

11-20-2015, 08:20 PM	#47
scooder Senior Member Join Date: Jul 2010 Posts: 2,597	Re: here we go again... does anyone make 3 7/8 Chris, There's a lot of Ford pistons out there with 5/16" from the crown edge to top of first ring. These won't reach the top with an 1/8" stroke. Also all the OEM Ford pistons have the crown edge quite a bit lower than the deck. These both make the use of them with the 1/8" stroke ideal. Martin.