Thread: here we go again... does anyone make 3 7/8
View Single Post
Old 11-20-2015, 06:05 AM   #34
OHV DeLuxe
Senior Member
 
Join Date: May 2010
Location: Norway
Posts: 318
Default Re: here we go again... does anyone make 3 7/8
Here is one Jim Khougaz did in 1956 at CT-Automotive.
I started a thread here about pistons and was advised to use stock Ford pin height.
Attached Images
File Type: jpg 20150831_221525_LLS_resized_1.jpg (37.6 KB, 42 views)
File Type: jpg 20150831_221606_LLS_resized_1.jpg (23.6 KB, 36 views)
File Type: jpg 20150831_221448_LLS_resized_1.jpg (40.5 KB, 32 views)
File Type: jpg 20150831_221323_LLS_resized_1.jpg (31.5 KB, 34 views)
File Type: jpg 20150831_221245_LLS_resized_1.jpg (29.2 KB, 33 views)
OHV DeLuxe is offline   Reply With Quote