The Ford Barn - View Single Post - here we go again... does anyone make 3 7/8

Alaska Jim · 11-18-2015, 08:24 PM

I think you may be able to use the 255 merc. pistons, but am not sure. was always going to check into this. my brother has one of these 3 -7/8 cranks.

11-18-2015, 08:24 PM	#9
Alaska Jim Senior Member Join Date: May 2010 Location: Palmer, Alaska Posts: 1,594	Re: here we go again... does anyone make 3 7/8 I think you may be able to use the 255 merc. pistons, but am not sure. was always going to check into this. my brother has one of these 3 -7/8 cranks.