The Ford Barn - View Single Post

Tinbasher · 10-27-2015, 02:37 PM

Use the PPG line of products. Get the TECH SHEETS and read them through. You'll find everyone has their way that works for them due to the conditions and the cost they have to work with. I just finished a pair of Front fenders and had to strip them to bare metal as they had been done in Lacquer and cracked and the moisture went down to the metal. If they have of used Epoxy primer and urethane products the fenders wouldn't have needed to be done. Lacquer in this area only lasts 3 to 5 years. Urethane products 30 years.
A cost that could have been avoided using a different product.

My thoughts: John Poole

10-27-2015, 02:37 PM	#3
Tinbasher Senior Member Join Date: May 2010 Location: Innisfil, Ontario Canada Posts: 1,219	Re: Primer Surfacer for PPG Concept paint Use the PPG line of products. Get the TECH SHEETS and read them through. You'll find everyone has their way that works for them due to the conditions and the cost they have to work with. I just finished a pair of Front fenders and had to strip them to bare metal as they had been done in Lacquer and cracked and the moisture went down to the metal. If they have of used Epoxy primer and urethane products the fenders wouldn't have needed to be done. Lacquer in this area only lasts 3 to 5 years. Urethane products 30 years. A cost that could have been avoided using a different product. My thoughts: John Poole