The Ford Barn - View Single Post

Tom Wesenberg · 10-25-2015, 01:18 AM

Unless it's actually worn out there is no need to replace it. Total time on a starter is very little and the rear bushing has very little load on it. That said, if I had to replace the bushing (I've only had to do a couple) I either bought it from Bert's, Bratton's, or Snyder's, and it fit fine.

I also have a very good seal and bearing store about 5 miles away where I can buy parts if I need to.

10-25-2015, 01:18 AM	#3
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Starter bushing, brush end Unless it's actually worn out there is no need to replace it. Total time on a starter is very little and the rear bushing has very little load on it. That said, if I had to replace the bushing (I've only had to do a couple) I either bought it from Bert's, Bratton's, or Snyder's, and it fit fine. I also have a very good seal and bearing store about 5 miles away where I can buy parts if I need to.