The Ford Barn - View Single Post

bobH · 09-21-2015, 01:31 PM

You didn't ask, but if it were me, I'd replace the tt and d/s with earlier parts, or fabricated parts. I never did like the 'skinny' d/s or center bearing.
(And, yes, I do have one car, 47, that uses those parts. I just prefer what's in my 34.)
For your case, is it possible to remove the center (now non-center) bearing, and install a fabricated tube-type d/s? This could be made from a 34 d/s, or fabricated. There used to be a 'kit' available for this. I'm unsure if it's still for sale?

09-21-2015, 01:31 PM	#3
bobH Senior Member Join Date: May 2010 Location: so cal, placerville, vegas Posts: 1,436	Re: Shortened rear end for 32 You didn't ask, but if it were me, I'd replace the tt and d/s with earlier parts, or fabricated parts. I never did like the 'skinny' d/s or center bearing. (And, yes, I do have one car, 47, that uses those parts. I just prefer what's in my 34.) For your case, is it possible to remove the center (now non-center) bearing, and install a fabricated tube-type d/s? This could be made from a 34 d/s, or fabricated. There used to be a 'kit' available for this. I'm unsure if it's still for sale?