The Ford Barn - View Single Post - TECH REQUEST: Removing Head Studs From The Block

BILL WZOREK · 05-07-2010, 09:05 PM

I wish I could do pictures! snapon Has a real good stud removal toolset.
It is like a Colet from a lathe but threaded on the inside ,you thread this on to the stud then install the outer portion it has a bolt that you tighten down on to the colet,when tight you use the nut that is part of the outer portion and turn the stud out.
It has not failed me yet,( Should not have said that )it may change my luck.

05-07-2010, 09:05 PM	#4
BILL WZOREK Senior Member Join Date: May 2010 Location: Florence Ma. Posts: 2,404	Re: TECH REQUEST: Removing Head Studs From The Block I wish I could do pictures! snapon Has a real good stud removal toolset. It is like a Colet from a lathe but threaded on the inside ,you thread this on to the stud then install the outer portion it has a bolt that you tighten down on to the colet,when tight you use the nut that is part of the outer portion and turn the stud out. It has not failed me yet,( Should not have said that )it may change my luck.