Quote:
Originally Posted by rocket1
I have a trans ready to go back in,from the end of the u joint to the bell is approx.15/16 of an inch,your u joint appears to be sticking out to far,drive shaft bottoming out,something not right in the trans,most likely.
|
I was wondering what you measured, but I assumed you held the bell to the rear of the bearing retainer flange?
I just measured my U-joint to the flange of the bearing retainer and got 3 1/8" when I hold the U-joint slined output horizontal.
Here is a picture of the rear of my spare tranny ready to bolt in.