12-24-2014, 12:30 PM
|
#40
|
|
Senior Member
Join Date: May 2010
Location: Daytona Beach, Fl & Spencer, W. Va,
Posts: 4,449
|
Re: Heaters?
Quote:
Originally Posted by keith oh
My 35 has a manifold heater much like the Model A heater that uses the engine fan air blowing over a exhaust manifold heat exchanger directly through a hole in the firewall. I have not seen any others like it. It does take the edge off if its not to cold out. Has anybody else have one like it?
|
keith oh ........................
It sounds like you might have a GENUINE FORD accessory heater. If it is like this one, you do. They are pretty scarce.
Also shown, is the original FORD adjustment device.
I believe the lower inlet tube, in the third photo, is the correct one.
MIKE  (mikeburch)
CLICK ON PHOTOS TO ENLARGE
|
|
|