Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 16 of 16
Search took 0.00 seconds. Search: Posts Made By: Harley Dean
Forum: Early V8 (1932-53) 07-07-2019, 06:29 PM
Replies: 9
Views: 1,648
Posted By Harley Dean
Re: F1 Spare Tire Carrier Nut

I believe I have extra one .I will look for it tomorrow. Dean
Forum: Early V8 (1932-53) 11-18-2017, 09:00 PM
Replies: 9
Views: 1,603
Posted By Harley Dean
Columbia in a 1941 Ford pickup

A friend of mine has a Columbia two speed he would like to install in a 1941 Ford half ton pickup. Has any one done this swap? The Columbia was from a 1947 Ford. He wants me to help him install it...
Forum: Early V8 (1932-53) 07-18-2016, 10:10 AM
Replies: 11
Views: 1,386
Posted By Harley Dean
Re: 50 Ford running poor at higher rpms....

accelerator pump?
Forum: Early V8 (1932-53) 03-03-2016, 11:26 AM
Replies: 18
Views: 11,024
Posted By Harley Dean
Re: 1948 - 1952 truck 12 volt wiring harness choices?...

Got mine from Tyree Harris for my 48 f1. He has a add in the v8 Times. Looks like the original and was easy to install.
Forum: Early V8 (1932-53) 02-29-2016, 12:34 PM
Replies: 13
Views: 1,935
Posted By Harley Dean
Re: '49 F1 back on the road!

Check the bushings in your front springs. They could be worn out, and have a slop in them.
Forum: Early V8 (1932-53) 02-18-2016, 12:23 PM
Replies: 7
Views: 1,555
Posted By Harley Dean
Re: 1949 F1 Dana 41 rear end keeps leaking, don't know what to do!

I had the same problem with my 48 F1. mine was leaking from cover the on the back and dripping from the drain plug.
Forum: Early V8 (1932-53) 02-17-2016, 01:22 PM
Replies: 24
Views: 4,485
Posted By Harley Dean
Re: Best way to clean out a carb?

Make your self a soda blaster, easy to do and leaves a smooth surface.
Forum: Early V8 (1932-53) 01-16-2015, 09:46 PM
Replies: 500
Views: 115,981
Posted By Harley Dean
Re: Fordbarn Average Age

I am 4 years older than my 1948 F1.
Forum: Early V8 (1932-53) 07-15-2014, 09:14 AM
Replies: 1
Views: 1,362
Posted By Harley Dean
50 Merc. overdrive transmission

I have a 50 Mercury overdrive in my 48 F1. I went for 50 mile ride yesterday. A couple hours later I noticed a big oil leak under the transmission. I'm guessing the vent is not working. I could not...
Forum: Early V8 (1932-53) 05-06-2014, 08:21 PM
Replies: 11
Views: 2,596
Posted By Harley Dean
Re: 1948-1950 ford pickup question

mtflat I blasted my firewall and there were no stamping at all. Dean
Forum: Early V8 (1932-53) 05-04-2014, 08:51 PM
Replies: 11
Views: 2,596
Posted By Harley Dean
Re: 1948-1950 ford pickup question

mtflat My 48 glass is dated Nov. 1947 and it has two water drain tubes on each side of the windshield that exit on the side of the cowl. The back of the cab is smooth, no ribs, like a 47.It has...
Forum: Early V8 (1932-53) 05-03-2014, 08:45 PM
Replies: 11
Views: 2,596
Posted By Harley Dean
Re: 1948-1950 ford pickup question

My early 48 has the smooth back. I'm sure it was built Dec. of 47. Dean
Forum: Early V8 (1932-53) 03-19-2014, 07:36 PM
Replies: 15
Views: 2,338
Posted By Harley Dean
Re: Source for black crackle finish ?

Harley Davidson dealers have it for the Evo engines. Dean
Forum: Early V8 12-29-2013, 01:08 PM
Replies: 0
Views: 730
Posted By Harley Dean
working horn for a 48 F1

My horn mounts in front of the radiator on the drivers side. Dean
Forum: Early V8 (1932-53) 11-05-2012, 08:56 PM
Replies: 2
Views: 1,130
Posted By Harley Dean
Re: Need a piece of F1 cab.

Hi Don,I have a 50 cab thats going to the junk yard.How big of a section do you need and where do you live? Dean
Forum: Early V8 (1932-53) 01-17-2012, 09:35 PM
Replies: 8
Views: 3,628
Posted By Harley Dean
Re: Removing king pins on 48 F1

When I replaced bushings in my 48 I used my torch and got the king pins cherry red and a BFH. I had goggles on for eye protection,but a piece of the drift broke off hitting my ear,was bleeding like a...
Showing results 1 to 16 of 16

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:17 AM.