Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 176
Search took 0.02 seconds.
Search: Posts Made By: shoe box Jack
Forum: Early V8 (1932-53) Yesterday, 01:06 PM
Replies: 20
Views: 373
Posted By shoe box Jack
Re: New Rebuild Overheating

I had the same problem with the 49 7years ago after losing half the summer I changed the intake end of problem . Jack.
Forum: Early V8 (1932-53) 09-24-2020, 10:21 AM
Replies: 1
Views: 112
Posted By shoe box Jack
over drive cabel

While driving the 49 the OD. cable works it,s way down in OD then goes into free wheeling?. Has anyone had this problem .So far I have a large clothe pin on the cable it works. Jack.
Forum: Early V8 (1932-53) 09-20-2020, 07:28 AM
Replies: 17
Views: 583
Posted By shoe box Jack
Re: E 3 spark plugs

Thanks 51 Merc. It looks like they are pre. gaped?. Jack.
Forum: Early V8 (1932-53) 09-19-2020, 03:36 PM
Replies: 17
Views: 583
Posted By shoe box Jack
E 3 spark plugs

Watching NASCAR they are advertising E 3 spark plugs, has any one tried them. Jack
Forum: Early V8 (1932-53) 09-19-2020, 10:26 AM
Replies: 3
Views: 236
Posted By shoe box Jack
Re: 49 ford push button radio

Thanks Tom, your wright there is only 1 AM station I could find. I would rather listen to the smittys anyway . Jack
Forum: Early V8 (1932-53) 09-18-2020, 01:48 PM
Replies: 3
Views: 236
Posted By shoe box Jack
49 ford push button radio

HI guys how do I set the push buttons on the radio so it will stop on the station ?. thanks, Jack
Forum: Early V8 (1932-53) 09-02-2020, 01:26 PM
Replies: 17
Views: 770
Posted By shoe box Jack
Re: Won't go into overdrive when hot.

Thanks Mac. VP. Just ordered a 4 wire 6 volt relay. Thanks; Jack. [49 ford.]
Forum: Early V8 (1932-53) 09-01-2020, 12:01 PM
Replies: 17
Views: 770
Posted By shoe box Jack
Re: Won't go into overdrive when hot.

Hi guys; I'm having the same problem with the 49 is there a 4 wire 6 volt relay ?. thanks for any info. Jack.
Forum: Early V8 (1932-53) 08-22-2020, 06:19 PM
Replies: 9
Views: 327
Posted By shoe box Jack
Re: addvertising

Thanks guys. I started over as a new member and all is good. Jack.
Forum: Early V8 (1932-53) 08-22-2020, 02:26 PM
Replies: 9
Views: 327
Posted By shoe box Jack
addvertising

It looks like the ford barn is turning in-to an advertising center. Jack.
Forum: Early V8 (1932-53) 08-19-2020, 07:04 AM
Replies: 4
Views: 294
Posted By shoe box Jack
Re: temperature senders

Thanks for the reply guys the sender is on the drivers side. With it on hooked the heat gauge reads normal . Jack.
Forum: Early V8 (1932-53) 08-18-2020, 02:14 PM
Replies: 4
Views: 294
Posted By shoe box Jack
temperature senders

I have a temp. sender that reads hot all the time. Is there any way they will come apart?. I;m trying to save 55.00. dollars. thanks for any info. Jack .
Forum: Early V8 (1932-53) 08-17-2020, 07:03 AM
Replies: 4
Views: 253
Posted By shoe box Jack
Re: heat sending units

Thanks for the info guys I will try to safe it. Jack.
Forum: Early V8 (1932-53) 08-16-2020, 09:22 AM
Replies: 4
Views: 253
Posted By shoe box Jack
heat sending units

my heat gauge was reading hot all the time. I took the wire off the unit on the drivers side an all is good. The unit on the driver side must be shorting out?? Thanks for any info. Jack.
Forum: Early V8 (1932-53) 08-07-2020, 02:44 PM
Replies: 6
Views: 320
Posted By shoe box Jack
Re: 94 carb.

Hi . I set the idle at 500. The vac. gauge read 19 in. the rpm now is 700 the dwell is 34 ?? is that good or ok. dis. is a chev. the air scews are 1 1/2 turns out. starts and runs good. thanks again...
Forum: Early V8 (1932-53) 08-06-2020, 01:10 PM
Replies: 6
Views: 320
Posted By shoe box Jack
94 carb.

the two low speed idle jets on the back off the carb. is two and 1/2 turns out enough ?. thanks for any info. Jack.
Forum: Early V8 (1932-53) 07-27-2020, 10:47 AM
Replies: 6
Views: 446
Posted By shoe box Jack
Re: Exhaust Sound and Engine Temp

I like the strait pipe. Jack.
Forum: Early V8 (1932-53) 07-20-2020, 01:52 PM
Replies: 15
Views: 624
Posted By shoe box Jack
Re: More Mercury Scenery

Thanks for the ride, It reminded me of a moonshine movie I ;ve seen . Jack.
Forum: Early V8 (1932-53) 07-19-2020, 08:48 AM
Replies: 11
Views: 541
Posted By shoe box Jack
Re: power valve

Thanks Petehoovie. Jack.
Forum: Early V8 (1932-53) 07-18-2020, 03:11 PM
Replies: 11
Views: 541
Posted By shoe box Jack
Re: power valve

thanks guys for the come back. Tubman how do I get in touch with charlie ny. Thanks again Jack.
Forum: Early V8 (1932-53) 07-18-2020, 11:49 AM
Replies: 21
Views: 868
Posted By shoe box Jack
Re: Water pump comparisons

Skips pumps worked for me. Jack.
Forum: Early V8 (1932-53) 07-18-2020, 11:44 AM
Replies: 11
Views: 541
Posted By shoe box Jack
power valve

I'm replacing the pv. in the 94 carb. I have the pv. fairly tight and it still seeps a little, how tight should it be??. thanks for any info. Jack.
Forum: Early V8 (1932-53) 07-10-2020, 11:54 AM
Replies: 3
Views: 317
Posted By shoe box Jack
Re: fender skirts

Thanks for the reply. The car is a friend of mine. and he bought a pair of fender skirts there is no where on the car or skirt to fasten them on? Jack.
Forum: Early V8 (1932-53) 07-09-2020, 01:15 PM
Replies: 3
Views: 317
Posted By shoe box Jack
fender skirts

On a 1953 ford car what holds the fender skirts on? thanks for any info. Jack
Forum: Early V8 (1932-53) 07-07-2020, 01:42 PM
Replies: 3
Views: 213
Posted By shoe box Jack
Re: 49 horn

Thanks; Rotorwrench great info. Jack.
Showing results 1 to 25 of 176

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:45 AM.