Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: johnneilson
Forum: Model A (1928-31) 05-13-2021, 02:51 PM
Replies: 25
Views: 8,636
Posted By johnneilson
Re: Intake & exhaust manifold torque

Large
Forum: Model A (1928-31) 05-12-2021, 07:12 PM
Replies: 25
Views: 8,636
Posted By johnneilson
Re: Intake & exhaust manifold torque

correct, IF using brass nuts and concave washers.

Typically when they don't seal the hardware is replaced with higher grade hardware.

John
Forum: Model A (1928-31) 05-12-2021, 07:02 PM
Replies: 25
Views: 8,636
Posted By johnneilson
Re: Intake & exhaust manifold torque

Same size thread as head stud into same block materials
Forum: Model A (1928-31) 05-12-2021, 10:37 AM
Replies: 25
Views: 8,636
Posted By johnneilson
Re: Intake & exhaust manifold torque

The other potential is the studs themselves.
If inferior quality, they will yield and not clamp tight enough.
J
Showing results 1 to 4 of 4

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:35 PM.