Forum: Early V8 (1932-53)
Yesterday, 11:40 AM
|
Replies: 6
Views: 309
Re: EAB cam
Try Southside Obsolete in MN. Fred might have one.
|
Forum: Early V8 (1932-53)
05-19-2024, 03:29 PM
|
Replies: 5
Views: 211
Re: 1935 Deck Lid Handle Lock Removal
You need to have the key or the master keys. There is a spring loaded button down in that hole. The key inserted then turned with the slot up will enable you to push that button down then you can...
|
Forum: Early V8
05-14-2024, 10:57 AM
|
Replies: 0
Views: 61
|
Forum: Early V8 (1932-53)
05-13-2024, 02:16 AM
|
Replies: 9
Views: 508
|
Forum: Early V8
05-10-2024, 12:38 PM
|
Replies: 0
Views: 117
|
Forum: Early V8 (1932-53)
05-09-2024, 02:30 PM
|
Replies: 16
Views: 680
Re: Gas under carbs on manifold
NO, it might be leaking from those or 1 of those 3 caps at the bottom of the bowl. Just a sealer that gasoline won't affect on those gaskets.Just squeeze a bit on your finger and wipe it on each...
|
Forum: Early V8 (1932-53)
05-09-2024, 02:23 PM
|
Replies: 23
Views: 872
Re: Disc brakes for wide-5 drums
I had pulled the 39 trans and banjo rear out of my 36 ,installed a T5 and a 57 9" rear hence I had put the Speedway Mopar rotor disc brake kit in front (so I would have the late Ford bolt pattern)...
|
Forum: Early V8 (1932-53)
05-09-2024, 11:27 AM
|
Replies: 23
Views: 872
|
Forum: Early V8 (1932-53)
05-09-2024, 09:22 AM
|
Replies: 23
Views: 872
Re: Disc brakes for wide-5 drums
Get these from Speedway and have the 5.5 pattern put in them
https://www.speedwaymotors.com/Speedway-Wide-5-Wheel-Adapter-5-on-4-3-4-Inch,29179.html
|
Forum: Early V8 (1932-53)
05-09-2024, 12:30 AM
|
Replies: 53
Views: 2,260
Re: Hot rod steering box
Using the F1 will change the angle where it meets the 32 column drop so that you will have to figure out. New Hudson style steerings are being made by Neal in CA. He is on here as well as the Hamb....
|
Forum: Early V8 (1932-53)
05-09-2024, 12:21 AM
|
Replies: 16
Views: 680
Re: Gas under carbs on manifold
I had that leak issue and it was the gasket seal issue at the jet access screws. I took the 3 screw caps out and used Blue Hylomar in a tube,wiped it on those 3 thin gaskets,reassembled,let dry and...
|
Forum: Early V8 (1932-53)
05-08-2024, 04:28 AM
|
Replies: 23
Views: 872
Re: Disc brakes for wide-5 drums
Speedway. For my 36 coupe. I bought the kit for 37-41 spindles with Mopar rotors with the 5X4.5 since I had the 57 Ford wagon 9" rear end.I then bought the adapters to mount the wide 5's.
|
Forum: Early V8 (1932-53)
05-05-2024, 03:38 AM
|
Replies: 34
Views: 2,039
Re: Spring removal and Columbia installation
The axles are all connected with the carriier along with the ring gear. It all comes out the left side after removing the left axle housing . Then remove the right axle housing.
|
Forum: Early V8 (1932-53)
05-03-2024, 01:47 AM
|
Replies: 17
Views: 634
Re: 1936 driver side door latch
You need this clip that slips thru the slot on the frame and holds the spring in place. Some vendors may have them or you possibly can fabricate one.
Maybe this 2nd pic is better.You can see that...
|
Forum: Early V8 (1932-53)
05-01-2024, 11:24 AM
|
Replies: 31
Views: 2,869
|
Forum: Early V8 (1932-53)
04-30-2024, 12:05 PM
|
Replies: 10
Views: 432
|
Forum: Early V8 (1932-53)
04-30-2024, 09:32 AM
|
Replies: 10
Views: 432
|
Forum: Early V8 (1932-53)
04-30-2024, 12:19 AM
|
Replies: 3
Views: 338
Re: 32 rear window winder handle
Mold mark?.Hard to see in that pic you posted.Stant has a round logo that can bee seen under 32 radiator caps and even on the grille bezel
|
Forum: Early V8 (1932-53)
04-28-2024, 12:01 AM
|
Replies: 10
Views: 668
|
Forum: Early V8 (1932-53)
04-26-2024, 08:52 AM
|
Replies: 25
Views: 1,054
|
Forum: Early V8 (1932-53)
04-24-2024, 02:53 AM
|
Replies: 14
Views: 864
Re: No Brake Lights
Replace the switch.I stopped using those MC switches or in line hydraulic switches years ago as they are a pain.The lever switch sold by Speedway ($7,now 11.99) mounted on the frame ,easy to mount...
|
Forum: Early V8 (1932-53)
04-22-2024, 11:16 AM
|
Replies: 7
Views: 498
|
Forum: Early V8 (1932-53)
04-22-2024, 10:10 AM
|
Replies: 25
Views: 1,672
|
Forum: Early V8 (1932-53)
04-21-2024, 01:13 AM
|
Replies: 7
Views: 498
Re: Cleaning a Hydrostatic fuel gauge
When using hydrochloric acid to clear the line I do a rinse with acetone or laquer thinner several times and low pressure compressed air to blow it all out. If the line does not clear with the acid...
|
Forum: Early V8 (1932-53)
04-20-2024, 12:12 AM
|
Replies: 8
Views: 403
Re: 32 bb v8 radiator
US Radiators in Arkansas.They moved from Los Angeles a few yrs ago.A friend here just bought one for his 34 running a 59AB and very happy.Custom made Brass or Aluminum.They send you a work sheet for...
|