Forum: Early V8 (1932-53)
06-24-2022, 01:36 PM
|
|
Replies: 14
Views: 549
Re: 1932 Ford rear brake drum questions
Use J&G Brake Drum Relining & Refurbishing www.jgrelining.com/ they will reline & refurbished your original brake drums and also re-arc your brake shoes to the drum.
|
|
Forum: Early V8 (1932-53)
05-25-2022, 10:07 PM
|
|
Replies: 6
Views: 400
1934 Fuel Line
Who makes a good reproduction 1934 fuel line this is the short rubber fuel line between the fuel pump and the main gas line? The one I have is only 5 years old and it is all cracked and just started...
|
|
Forum: Early V8 (1932-53)
12-04-2021, 11:28 AM
|
|
Replies: 2
Views: 392
|
|
Forum: Early V8 (1932-53)
08-03-2021, 03:26 PM
|
|
Replies: 12
Views: 958
Re: 34 Coil Carbon Brush
Terry, I removed the rebuilt Bubba's distributor and the mechanical advance weights were not stuck but when I compared the tension on the vacuum brake piston compared to my original distributor it...
|
|
Forum: Early V8 (1932-53)
08-02-2021, 03:51 PM
|
|
Replies: 12
Views: 958
Re: 34 Coil Carbon Brush
Yes but Bubba set up the rebuilt distributor that i just installed yesterday and he would have had that all set up!
|
|
Forum: Early V8 (1932-53)
08-02-2021, 10:14 AM
|
|
Replies: 12
Views: 958
Re: 34 Coil Carbon Brush
Terry, I have already installed a new brush into the coil. I just cant figure out way I dont have any acceleration.
|
|
Forum: Early V8 (1932-53)
08-02-2021, 09:54 AM
|
|
Replies: 12
Views: 958
34 Coil Carbon Brush
Yesterday I took my 34 out for a drive and it ran great until I stopped. About 20 minutes later I started it to drive home and I could only accelerate to about 35 mph with the engine stumbling. The...
|
|
Forum: Early V8 (1932-53)
06-24-2021, 04:38 PM
|
|
Replies: 5
Views: 506
|
|
Forum: Early V8 (1932-53)
03-26-2021, 04:31 PM
|
|
Replies: 11
Views: 1,552
|
|
Forum: Early V8 (1932-53)
03-09-2021, 05:58 PM
|
|
Replies: 46
Views: 3,537
|
|
Forum: Early V8 (1932-53)
02-23-2020, 02:59 PM
|
|
Replies: 9
Views: 954
|
|
Forum: Early V8 (1932-53)
02-23-2020, 01:40 PM
|
|
Replies: 9
Views: 954
|
|
Forum: Early V8 (1932-53)
02-23-2020, 01:15 PM
|
|
Replies: 9
Views: 954
Re: 1934 ford tack strip
I used hard leather belting I installed the top 3 years ago and the tacks have held with no problems.
|
|
Forum: Early V8 (1932-53)
07-16-2019, 10:12 AM
|
|
Replies: 10
Views: 1,657
|
|
Forum: Early V8 (1932-53)
07-16-2019, 10:02 AM
|
|
Replies: 15
Views: 1,741
Re: Rattle - Help!
Before I re-restored my 34 roadster I had the same problem and it was the muffler hitting the frame.
|
|
Forum: Early V8 (1932-53)
06-21-2019, 11:55 AM
|
|
Replies: 13
Views: 1,375
Re: Side Anti Rattle bumper on a 34 Rumble lid
Here is a picture of the sheet metal retainer/dam which contains the water and drains out the holes in the rear of the floor pan. Unfortunately you cant see the drain holes in the picture but they...
|
|
Forum: Early V8 (1932-53)
06-19-2019, 01:41 PM
|
|
Replies: 13
Views: 1,375
|
|
Forum: Early V8 (1932-53)
06-19-2019, 11:17 AM
|
|
Replies: 13
Views: 1,375
|
|
Forum: Early V8 (1932-53)
04-19-2019, 09:56 AM
|
|
Replies: 104
Views: 17,051
Re: Roy Nacewicz
RIP Roy I only wish that RIP meant "Return if Possible" How lucky I am to have known you the guidance that you gave me on the bolting requirements for my 34 roadster during its restoration was so...
|
|
Forum: Early V8 (1932-53)
03-19-2019, 09:16 PM
|
|
Replies: 42
Views: 8,355
|
|
Forum: Early V8 (1932-53)
12-26-2018, 11:27 AM
|
|
Replies: 40
Views: 4,866
Re: 1934 Spark/ Ignition Issue
Send an old condenser to Bubbas Ignition and have him build you a Vertex Mag "lifetime" condenser modified to fit a 34 helmet distributor also send Skip your coil and have him modernized it and your...
|
|
Forum: Early V8 (1932-53)
11-12-2018, 10:36 AM
|
|
Replies: 17
Views: 3,315
|
|
Forum: Early V8 (1932-53)
11-04-2018, 09:39 PM
|
|
Replies: 19
Views: 1,967
|
|
Forum: Early V8 (1932-53)
10-13-2018, 10:27 AM
|
|
Replies: 10
Views: 1,282
|
|
Forum: Early V8 (1932-53)
10-06-2018, 09:39 AM
|
|
Replies: 16
Views: 2,427
|
