Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Jon E
Forum: Model A (1928-31) 06-19-2023, 09:43 AM
Replies: 5
Views: 682
Posted By Jon E
Re: Tappet Cups for Miller/Cragar OHV?

Dan and John,

I currently have the factory original lifters, so they are solid without any provision for an adjustment screw.

Attached below are a few photos of the actual part that I'm looking...
Forum: Model A (1928-31) 06-18-2023, 10:21 PM
Replies: 5
Views: 682
Posted By Jon E
Tappet Cups for Miller/Cragar OHV?

Hello,

I am in need of some replacement tappet cups for my Miller/Cragar OHV. These are the small adapters that sit on top of the lifter and have a cup on the opposite side to receive the pushrod....
Forum: Model A (1928-31) 09-24-2021, 08:36 AM
Replies: 24
Views: 4,842
Posted By Jon E
Re: Having trouble getting new Miller-Cragar setup to run

I tried to, but I received the following message:
Forum: Model A (1928-31) 09-22-2021, 08:40 PM
Replies: 24
Views: 4,842
Posted By Jon E
Re: Having trouble getting new Miller-Cragar setup to run

Can anyone recommend a source for a mechanical pump that will fit a 32 B?

If I can't find a mechanical pump, I guess I will have to install an in line electric pump.

This car is a period...
Forum: Model A (1928-31) 09-19-2021, 08:55 AM
Replies: 24
Views: 4,842
Posted By Jon E
Re: Having trouble getting new Miller-Cragar setup to run

Thanks for the responses.

In answer to your questions, I am located in the NW FL South Alabama area.

It was a fresh build for the previous owner and was run very little. Mostly just to drive it...
Forum: Model A (1928-31) 09-17-2021, 03:05 PM
Replies: 24
Views: 4,842
Posted By Jon E
Having trouble getting new Miller-Cragar setup to run

Hello,

This is my first post here, but I have been reading and searching these forums for a while.

I recently purchased a 28 with a Miller-Cragar OHV which is the first early Ford I have ever...
Showing results 1 to 6 of 6

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:50 AM.