Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 85
Search took 0.01 seconds.
Search: Posts Made By: ceejay
Forum: Early V8 (1932-53) 05-01-2017, 02:51 AM
Replies: 17
Views: 1,195
Posted By ceejay
Re: 33 phaeton 4 cylinder- crank pulley too close to U bolts

Thank you everyone for your input !!

From Frank West's photo it is very clear that my engine is too far forward by a fair amount.

The height is fine because the pulley center lines up with the...
Forum: Early V8 (1932-53) 04-28-2017, 11:51 AM
Replies: 17
Views: 1,195
Posted By ceejay
Re: 33 phaeton 4 cylinder- crank pulley too close to U bolts

David you mentioned some interesting possibilities... How does one differentiate a 33 cross member from a 34 ?

Is it possible that my car was originally fitted with this cross member as it was...
Forum: Early V8 (1932-53) 04-28-2017, 03:12 AM
Replies: 17
Views: 1,195
Posted By ceejay
Forum: Early V8 (1932-53) 04-28-2017, 03:09 AM
Replies: 17
Views: 1,195
Posted By ceejay
Re: 33 phaeton 4 cylinder- crank pulley too close to U bolts

This is the engine in it. It is quite possible that it not the correct type.
You folks will be able to tell by looking at the photo I guess
Forum: Early V8 (1932-53) 04-28-2017, 01:26 AM
Replies: 17
Views: 1,195
Posted By ceejay
33 phaeton 4 cylinder- crank pulley too close to U bolts

Hi all

My car is a 33 phaeton which currently has a flathead 4 cylinder model B engine.

I have not worked on the car after purchase much and have just run into a problem.

The crank pulley...
Forum: Early V8 (1932-53) 07-05-2015, 08:17 PM
Replies: 8
Views: 1,499
Posted By ceejay
Re: 33 pickup front and rear axles ok for phaeton ?

Thanks guys. I did take note of the previous comments about the torque tube and drive shaft.

I bought the 33 pickup 4 cyl. rear axle complete with torque tube and drive shaft but bought a V8...
Forum: Early V8 (1932-53) 07-05-2015, 01:50 PM
Replies: 8
Views: 1,499
Posted By ceejay
Re: 33 pickup front and rear axles ok for phaeton ?

Waking up an old post here but looking to get re confirmation of one point...
Is the 1933 4 cylinder pickup rear axle the same as the 33 V8 passenger car rear axle and do they both have the same...
Forum: Early V8 (1932-53) 10-11-2014, 12:46 AM
Replies: 9
Views: 1,063
Posted By ceejay
Re: 33 Wheelbase ? 4 cyl. shorter than V8 ?

http://restoreyourford.com/1933pcinfoid.shtml

This web site first quotes 106" wheelbase for 4 cylinder in the text and then says 112" in the table just below !! just goes to show that not all the...
Forum: Early V8 (1932-53) 10-10-2014, 02:00 PM
Replies: 8
Views: 2,117
Posted By ceejay
Re: Rear / side mount spare tire & trunk rack

I found photos of configurations which look odd.. have a look.

The Red Phaeton has the trunk positioned really far outside the body of the car. It seems to be configured to carry the rear spare...
Forum: Early V8 (1932-53) 10-10-2014, 01:50 PM
Replies: 9
Views: 1,063
Posted By ceejay
Re: 33 Wheelbase ? 4 cyl. shorter than V8 ?

Precisely ! I have been advised by another senior member that all 33's were the same wheelbase 112"

The info out there is wrong. Someone has posted the incorrect info on Wiki and every one else...
Forum: Early V8 (1932-53) 10-10-2014, 01:27 PM
Replies: 9
Views: 1,063
Posted By ceejay
33 Wheelbase ? 4 cyl. shorter than V8 ?

Hi all,

I'v been reading on a few web sites that in 1933, the 4 cylinder cars were 106" wheel base and the V8s were 112". Is this incorrect information ?

Surely, cars with the same style of...
Forum: Early V8 (1932-53) 10-09-2014, 11:34 PM
Replies: 8
Views: 2,117
Posted By ceejay
Re: Rear / side mount spare tire & trunk rack

Hmm.. twin side mounts were offered as an option on 32 cars weren't they ? so was it not an option on the 33's ? My car is a Right Hand Drive car. There is a 33 phaeton in Colombia which has twin...
Forum: Early V8 (1932-53) 10-09-2014, 02:55 PM
Replies: 8
Views: 2,117
Posted By ceejay
Rear / side mount spare tire & trunk rack

When 33 phaetons had 2 side mounted spare tires, did they ever have the rear spare also ? (making 3 spare tires on the car)

Did the side mounted spares ever have the steel covers on them ?

If...
Forum: Early V8 10-01-2014, 12:27 PM
Replies: 0
Views: 962
Posted By ceejay
33/34 Luggage (Trunk) Rack

Desperately looking for a luggage rack for my 33 Phaeton
Forum: Early V8 (1932-53) 04-28-2014, 12:49 PM
Replies: 2
Views: 745
Posted By ceejay
33 Phaeton V8 and 4 cyl. rear radius rods same ?

HI all,

My 33 Phaeton is a 4 cylinder car.

I am installing 35 flathead V8 with its matching gearbox + 33 4cylinder rear axle + 33 V8 torque tube and drive shaft.

My question is, can I use my...
Forum: Early V8 04-21-2014, 07:55 AM
Replies: 0
Views: 660
Posted By ceejay
33/34 Luggage (Trunk) Rack

Hi all,

I'm looking for a luggage / Trunk rack for my 33 Phaeton
Forum: Early V8 03-31-2014, 10:15 AM
Replies: 0
Views: 598
Posted By ceejay
33 Radiator and Torque tube complete

Hi all,

Im looking for a radiator and torque tube complete for my 33 V8 Phaeton.

Radiator core does not need to be good. I can replace the core.

Shipping to NJ
Forum: Early V8 (1932-53) 02-06-2014, 02:05 AM
Replies: 8
Views: 1,499
Posted By ceejay
33 pickup front and rear axles ok for phaeton ?

Hi all..

Here's the story...

My car is a 33 Phaeton which has a flat head 4 cylinder in it.

I want to fit the original style V8 into it.

In a previous post I asked about issues with the...
Forum: Early V8 (1932-53) 02-02-2014, 01:52 PM
Replies: 16
Views: 1,594
Posted By ceejay
Re: Which V8 for my car ?

Thank you ..

Are there any issues with the poured bearing engines ?
Forum: Early V8 (1932-53) 02-02-2014, 01:48 PM
Replies: 16
Views: 1,594
Posted By ceejay
Re: Which V8 for my car ?

since my car has a 4 cylinder drive line, I would need V8 engine, transmission, torque tube and rear axle ?
Forum: Early V8 (1932-53) 02-02-2014, 01:41 PM
Replies: 16
Views: 1,594
Posted By ceejay
Which V8 for my car ?

I all, I have a 33 Phaeton which needs a replacement engine.

I have an opportunity to buy a good 35 engine.

I take it, they went into insert main bearings in 36 ?

Is there anything to say...
Forum: Early V8 10-24-2013, 12:48 PM
Replies: 3
Views: 718
Posted By ceejay
17" wheels wanted

Hi all,

I need to buy a total of 6 wheels for my 33 Phaeton. (dual side mounts)

The wheels should be 17" correct ?

Any one has any for sale ? please let me know.

Thanks
Forum: Early V8 (1932-53) 11-12-2012, 01:02 PM
Replies: 9
Views: 1,459
Posted By ceejay
Re: 33/34 Front and rear Spring dimensions ??

Thank you all !

Jim has very kindly given me the measurements so I can now check how bad my springs are.
I will also look into if one of the blades may be broken.
Forum: Early V8 (1932-53) 11-11-2012, 09:09 AM
Replies: 9
Views: 1,459
Posted By ceejay
Re: 33/34 Front and rear Spring dimensions ??

thanks a lot Jim !! would not have easy for you to measure those from under the car... much appreciated !!!

Oh yes I do see what you mean.. i do need to have the correct wheel and tire size to...
Forum: Early V8 (1932-53) 11-11-2012, 08:30 AM
Replies: 9
Views: 1,459
Posted By ceejay
Re: 33/34 Front and rear Spring dimensions ??

Thanks guys for the input.

Since my fenders have been shaped wrong by previous restorer and my wheels are 16" 1935 wheels, can someone please give the correct measurement between the road and some...
Showing results 1 to 25 of 85

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:37 PM.