Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 131
Search took 0.01 seconds.
Search: Posts Made By: TMarsh
Forum: Model A (1928-31) Today, 10:40 AM
Replies: 14
Views: 381
Posted By TMarsh
Re: distributor swap out question

Did not think that through, do not hit
Forum: Model A (1928-31) Yesterday, 08:50 PM
Replies: 14
Views: 381
Posted By TMarsh
Re: distributor swap out question

It is messed up already, try an impact screw remover that you hit with a hammer.
Forum: Model A (1928-31) 03-18-2024, 09:03 PM
Replies: 29
Views: 1,531
Posted By TMarsh
Re: Deep knocking sound

Have heard of the generator hitting the side of the block. Engine was torn down twice before it was discovered. Best try to isolate the area before major teardown.
Forum: Model A (1928-31) 03-06-2024, 04:28 PM
Replies: 6
Views: 466
Posted By TMarsh
Re: New fuel shutoff valve, ball valve filter

Wrapped mine with tin foil. No problems so far, over 5000 miles.
Forum: Model A (1928-31) 01-31-2024, 10:09 PM
Replies: 23
Views: 1,602
Posted By TMarsh
Re: Light Wire Harness Bucket Seized/Issues

I think there are three different length light rods. Did you change the rod.
Forum: Model A (1928-31) 01-27-2024, 04:43 PM
Replies: 67
Views: 4,574
Posted By TMarsh
Re: Misfire mystery

Set timing using Les Andrews red book. Had a problem like you said, turned out that the NU REX wrench was off by a few degrees retard. When set with test light everything turned out OK. I think it...
Forum: Model A (1928-31) 01-23-2024, 03:49 PM
Replies: 15
Views: 1,214
Posted By TMarsh
Re: Electric wiper motor mount

Have one rotorwrench described from Snyders on my 30 coupe. Looks good and window opens, even though I dont drive in the rain on purpose. Meets state standards.
Forum: Model A (1928-31) 12-25-2023, 05:49 PM
Replies: 16
Views: 1,245
Posted By TMarsh
Re: Wheel Weights

Ditto Gene F
Forum: Model A (1928-31) 12-24-2023, 12:42 PM
Replies: 20
Views: 1,276
Posted By TMarsh
Re: My 1928 A Tudor steers very hard What ca I do?

Disconnect the pitman arm from the drag link to see if is the steering box or the front steering parts such as mentioned above.
Forum: Model A (1928-31) 12-09-2023, 06:37 PM
Replies: 11
Views: 954
Posted By TMarsh
Re: Adjusting Accelerator Assembly

Bends very easily without heat, you won't break it. Had to bend mine to get full throttle after I changed from a Zenith carburetor to a Tillyl. Have someone step on accelerator in car as you make...
Forum: Model A (1928-31) 11-06-2023, 11:10 AM
Replies: 9
Views: 1,257
Posted By TMarsh
Re: Arguementive Lubrication of The Model "A" & "AA"

Ok, I tend to agree with you. Can you give me a recommended schedule.
Forum: Model A (1928-31) 10-20-2023, 03:53 PM
Replies: 6
Views: 731
Posted By TMarsh
Re: window regulator

Just slips in the lower channel with some lube.
Forum: Model A (1928-31) 10-02-2023, 07:49 AM
Replies: 10
Views: 970
Posted By TMarsh
Re: Tilotson carb question

Marshall, you are correct it takes a person in the drivers seat to push on the accelerator to check for full throttle.
Forum: Model A (1928-31) 09-30-2023, 03:38 PM
Replies: 10
Views: 970
Posted By TMarsh
Re: Tilotson carb question

Marshall, you are the man or woman, I have about 5000 miles on my A I put together from buckets of parts. It runs great and I am proud of her. Had a Zenith and a friend of mine gave me a Tillotson...
Forum: Questions & Suggestions 09-09-2023, 08:35 AM
Replies: 0
Views: 522
Posted By TMarsh
Headlights

I got a set of focused headlights and adjusted them according to shop manual.
They work very well and I am pleased with the purchase.
My question is the headlights are now pointing slightly inward...
Forum: Model A (1928-31) 09-03-2023, 08:55 AM
Replies: 4
Views: 598
Posted By TMarsh
Re: retard lever problem

Had the same problem, try what nkminor suggested, when I used the nurex tool I had the same problem. not to say it was the tools fault, using the book method worked great, a little more trouble, but...
Forum: Model A (1928-31) 08-23-2023, 10:36 AM
Replies: 30
Views: 3,028
Posted By TMarsh
Re: Foam in Anti-freeze

Same problem changed anti freeze, cured problem
Forum: Model A (1928-31) 08-01-2023, 03:01 PM
Replies: 2
Views: 501
Posted By TMarsh
Re: Rumble Seat Solution?

I am 73 and found that zip ties work the best for me. If I had a young person available I would put the screws in. Zip ties work well and can be easily removed if you find a youngun to put the screws...
Forum: Model A (1928-31) 06-29-2023, 05:24 PM
Replies: 50
Views: 6,108
Posted By TMarsh
Re: Thermostat

When I move out of Northeast Texas I may consider a thermostat. Tried one and it gave me more problems than it was worth.
Forum: Model A (1928-31) 05-08-2023, 05:25 PM
Replies: 8
Views: 1,408
Posted By TMarsh
Re: Timing help, some clarification

use the red book system, I found the new rex off the same amount. Not blaming nu rex, just found the red book system to be more spot on.
Forum: Model A (1928-31) 03-22-2023, 08:38 PM
Replies: 13
Views: 2,008
Posted By TMarsh
Re: Water level

Radiator has baffle, I can look at a angle with a flashlight and see the tops of the tubes. I just fill it back up to cover the tubes. Have roofing nail in overflow tube and tube has been bent back...
Forum: Model A (1928-31) 03-22-2023, 06:34 PM
Replies: 13
Views: 2,008
Posted By TMarsh
Water level

Maybe I am just paranoid. I drive my car almost daily. I put my coupe together myself and it has a good radiator and clean block. It has a 165 degree thermostat and a temperature gauge in the car....
Forum: Model A (1928-31) 03-15-2023, 10:06 PM
Replies: 5
Views: 846
Posted By TMarsh
Brakes

Have 4000 miles on my coupe with no brake adjustment since everything rebuilt by me. Originally had 3/4 pedal travel, now have about one half pedal. Stops good and straight, cast iron drums, no...
Forum: Model A (1928-31) 03-10-2023, 09:42 PM
Replies: 19
Views: 2,363
Posted By TMarsh
Re: Value of Pair of 1927 Texas License Plates

Had my 30 coupe with YOM plates registered in Texas a couple of years ago. They gave me a small sticker and holder to put behind the plate that said it expired in 5 years. Plate for sticker was...
Forum: Model A (1928-31) 02-21-2023, 07:52 PM
Replies: 9
Views: 872
Posted By TMarsh
Showing results 1 to 25 of 131

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:51 PM.