Forum: Early V8 (1932-53)
03-14-2024, 11:11 AM
|
Replies: 5
Views: 396
|
Forum: Early V8 (1932-53)
11-09-2023, 02:32 PM
|
Replies: 13
Views: 777
|
Forum: Early V8 (1932-53)
08-16-2023, 06:13 PM
|
Replies: 21
Views: 1,562
|
Forum: Early V8 (1932-53)
07-16-2023, 03:34 PM
|
Replies: 16
Views: 822
|
Forum: Early V8 (1932-53)
07-16-2023, 03:31 PM
|
Replies: 16
Views: 822
|
Forum: Early V8 (1932-53)
07-16-2023, 09:49 AM
|
Replies: 16
Views: 822
|
Forum: Early V8 (1932-53)
02-07-2023, 05:36 PM
|
Replies: 17
Views: 1,591
Re: ignition lock cylinder
The 1/4 " pin is pressed in to hold the lock. You can use a drill to drill into it. Be sure the drill is smaller than the pin and go slow. You can put a screw or pick in the hole you drillrd to...
|
Forum: Early V8 (1932-53)
01-25-2023, 01:46 PM
|
Replies: 14
Views: 1,142
|
Forum: Early V8 (1932-53)
12-21-2022, 02:55 PM
|
Replies: 8
Views: 1,418
|
Forum: Early V8 (1932-53)
12-16-2022, 02:55 PM
|
Replies: 18
Views: 2,570
Re: Exhaust pipe removal
Bob56
I had to remove the radiator on my 37 Ford to get the front Passager side exhaust pipe to go in. Little bit of work it will fit.
|
Forum: Early V8 (1932-53)
09-17-2022, 05:22 PM
|
Replies: 5
Views: 781
Re: No key
You may want to contact 32Phil on the Barn. He makes keys for Hurd Locks and also repairs locks. He is very good and reasonable.
|
Forum: Early V8 (1932-53)
08-16-2022, 08:40 PM
|
Replies: 2
Views: 621
|
Forum: Early V8 (1932-53)
12-15-2021, 05:03 PM
|
Replies: 6
Views: 828
Re: 42-48 Convertible rear wood panels
Tracy
Attached are some photos of the convertible wood pieces. The photo of the top tray has dimensions, hope you can read them. Also, there is a couple photos of the wood divider that goes at...
|
Forum: Early V8 (1932-53)
02-03-2021, 11:41 AM
|
Replies: 41
Views: 7,975
|
Forum: Early V8 (1932-53)
01-25-2021, 05:14 PM
|
Replies: 44
Views: 8,186
|
Forum: Early V8 (1932-53)
12-19-2020, 12:00 PM
|
Replies: 23
Views: 2,537
|
Forum: Early V8 (1932-53)
11-29-2020, 11:34 AM
|
Replies: 22
Views: 3,389
Re: 39 trans
Around 1961 I was riding with a friend who had a stock 40 Ford sedan except for a stock 50 Olds engine. He had replaced the transmission a couple times before and had swore off mistreating it. He...
|
Forum: Early V8 (1932-53)
10-19-2020, 06:08 PM
|
Replies: 9
Views: 1,554
|
Forum: Early V8 (1932-53)
09-26-2020, 10:45 AM
|
Replies: 3
Views: 936
|
Forum: Early V8
09-01-2020, 03:12 PM
|
Replies: 1
Views: 637
|
Forum: Early V8
07-11-2020, 02:28 PM
|
Replies: 1
Views: 637
Chassis Engineering Front Sway Bar Kit
Chassis Engineering Front Sway Bar Kit for 1937-1940 Ford Model # SB3740F. This kit has never been installed and is in excellent condition. $175 includes shipping to lower 48.
|
Forum: Early V8
06-28-2020, 03:36 PM
|
Replies: 0
Views: 566
|
Forum: Early V8 (1932-53)
05-26-2020, 04:23 PM
|
Replies: 14
Views: 2,462
Re: My little red Ford Pickup
Jerry-
Before you start your brake rebuild, I recommend you talk to Richard Lacy http://www.earlyv8garage.net. He is an expert in hydraulic brake conversions for our old Fords. His advise may save...
|
Forum: Early V8
03-05-2020, 03:51 PM
|
Replies: 0
Views: 792
|
Forum: Early V8 (1932-53)
04-01-2019, 10:42 AM
|
Replies: 77
Views: 39,353
|