Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 10 of 10
Search took 0.00 seconds. Search: Posts Made By: The Liberator
Forum: Early V8 (1932-53) 01-15-2023, 03:11 AM
Replies: 25
Views: 4,035
Posted By The Liberator
Re: wide 5s

I’ve checked every wide 5 wheel at the swaps for the 5” but never found them. Good find.
Forum: Early V8 (1932-53) 01-15-2023, 03:00 AM
Replies: 21
Views: 4,385
Posted By The Liberator
Re: Ecklers

I have never had good luck with ecklers.
Forum: Early V8 (1932-53) 01-15-2023, 02:57 AM
Replies: 27
Views: 17,084
Posted By The Liberator
Re: Cartouche gone, where to get upholstery

Darn, right when I was thinking of ordering a kit too. Sad to hear these companies closing down.
Forum: Model A (1928-31) 01-15-2023, 02:41 AM
Replies: 24
Views: 6,232
Posted By The Liberator
Re: Which Valve Spring Compressor

I’ve just used the trusty old craftsman similar to the one pictured above with no issues.
Forum: Early V8 (1932-53) 01-15-2023, 02:28 AM
Replies: 20
Views: 3,119
Posted By The Liberator
Re: Navarro heads and the oil housing

I like the coupling nut idea because you can leave your studs alone and simply trim the nuts to proper height and bolt the bracket down.
Forum: Early V8 (1932-53) 01-15-2023, 02:24 AM
Replies: 20
Views: 3,557
Posted By The Liberator
Re: Need best way to remove diff. pinion shaft assembly

I agree with the press, even with heat still got a good pop from the pinion bearing!
Forum: Early V8 (1932-53) 01-15-2023, 02:16 AM
Replies: 6
Views: 1,093
Posted By The Liberator
Re: AC Electric Fuel Pump?

Be sure to check the pressure, I ran a low pressure electric fuel pump for a dual stromberg set up that actually produced more pressure than advertised. I had to run a low pressure regulator as well...
Forum: Early V8 (1932-53) 01-15-2023, 02:12 AM
Replies: 33
Views: 5,249
Posted By The Liberator
Re: Amazing new stud extractor

Looks like a good tool, almost looks like the extractor that has the sprag bearing design.
Forum: Early V8 (1932-53) 01-15-2023, 02:05 AM
Replies: 13
Views: 2,047
Posted By The Liberator
Re: What Gear Oil

I’ve ran the “600wt” form any of the early parts suppliers with good luck but often wondered if any heavy gear lube would be the same? Much easier to run to Napa then order it.
Forum: Early V8 (1932-53) 01-15-2023, 01:59 AM
Replies: 28
Views: 2,993
Posted By The Liberator
Re: Coumbia Control 37-41 for a 1932

So does any later speedo changer work on the early fords as well? IE: 46-48 on a 34? Thanks
Showing results 1 to 10 of 10

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:58 AM.