Forum: Model A (1928-31)
12-24-2023, 02:26 PM
|
Replies: 9
Views: 943
|
Forum: Model A (1928-31)
12-24-2023, 11:24 AM
|
Replies: 20
Views: 1,305
My 1928 A Tudor steers very hard What ca I do?
Purchased a 1928 Tudor that had been setting up for 20 years. Rebuilt Carb, Distributor and replaced the gas tank. Cranked it up and went to take a ride but it is very hard to steer. Jacked up front...
|
Forum: Early V8 (1932-53)
07-07-2021, 02:53 PM
|
Replies: 39
Views: 3,432
|
Forum: Early V8 (1932-53)
09-10-2020, 02:11 PM
|
Replies: 13
Views: 1,622
|
Forum: Early V8 (1932-53)
09-10-2020, 01:59 PM
|
Replies: 13
Views: 1,622
She looks good but she doesn’t run so good
When you drive the truck and let off the accelerator to slow down or stop for a red light it quits running. I have done everything I know of and wonder if someone out there might have a suggestion as...
|
Forum: Early V8
11-16-2018, 10:54 AM
|
Replies: 0
Views: 509
Wanted 8BA Block , Shortblock or running engine
WANTED I have a rebuilt 8 BA V8 that the block is cracked. Machine shop did not magniflux. I am looking for a good block to replace it. I will take a rebuilt shortblock if someone has one or a good...
|
Forum: Early V8 (1932-53)
03-11-2017, 11:49 AM
|
Replies: 19
Views: 14,607
|
Forum: Early V8 (1932-53)
07-13-2014, 01:27 PM
|
Replies: 5
Views: 2,838
|
Forum: Early V8 (1932-53)
07-12-2014, 11:04 AM
|
Replies: 15
Views: 8,595
Flathead Facts by John w Lawson
Thanks 38 coupe for suggestion the book. I just finished reading Flathead Facts by John W Lawson. A good book but kinda disappointing for what I was trying to find out. He takes an 8BA stock engine...
|
Forum: Early V8 (1932-53)
07-12-2014, 09:01 AM
|
Replies: 27
Views: 18,356
|
Forum: Early V8 (1932-53)
07-05-2014, 09:50 AM
|
Replies: 9
Views: 5,382
Changing distributor on a flathead V8 8BA
Anyone have any advice on changing the distributor on my 1950 8BA flathead.
Thought about going to Petronix electronic ignition and then read about the load-o-matic vacuum spark advancement and...
|
Forum: Early V8 (1932-53)
07-01-2014, 08:14 PM
|
Replies: 19
Views: 14,607
swapping a rear end in a 1950 F1 pickup
I am looking for information on swapping out my Dana 41 to a Dana 44 in a 1950 Ford F-1.
The truck has the original 8BA Flathead and 3 speed transmission. The Dana 41 has a 3.92 ratio rear end....
|