Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: flintcamp
Forum: Model A (1928-31) 04-22-2023, 11:38 PM
Replies: 12
Views: 1,809
Posted By flintcamp
Re: TCP global, any good?

I have painted more vehicles and boats than I would have preferred to and have used TCP Global on many of them. The Restoration Shop urethane looks good on older cars and goes on fine when mixed...
Forum: Model A (1928-31) 12-13-2022, 12:42 AM
Replies: 6
Views: 1,225
Posted By flintcamp
Re: 6volt positive ground

I'm no expert on the subject but when I have to jump a positive ground vehicle I connect the positive lead from the source to metal on the car to be jumped and the neg lead to the negative battery...
Forum: Model A (1928-31) 06-14-2022, 09:40 PM
Replies: 15
Views: 2,225
Posted By flintcamp
Re: Trailer width for a model A

When I got my Model A I rented a U-Haul that worked out well and easy to use. Years later, I bought a 16' tandem utility trailer with a fold down gate/ramp with a front winch to haul a variety of...
Forum: Model A (1928-31) 05-08-2022, 09:23 PM
Replies: 19
Views: 3,576
Posted By flintcamp
Re: Replacement 6V Battery

I recently bought an Interstate 1-VHD through a tire store for $95.00.
Forum: Model A (1928-31) 01-22-2020, 09:49 PM
Replies: 6
Views: 1,746
Posted By flintcamp
Re: Float-a-Motor rear mount

Thanks for all of your help. I have aluminum mounts but new rubbers and I'll keep any eye out for cracks. I finally figured out I was missing a rubber and a plate to keep the rubber on. Fabricated...
Forum: Model A (1928-31) 01-21-2020, 09:16 PM
Replies: 6
Views: 1,746
Posted By flintcamp
Float-a-Motor rear mount

I had a cobbled together a 31 coupe that I have been repairing for the last few years. I have a float a motor engine mount with new rubbers and a stock mount for the front. The suspension is all...
Forum: Model A (1928-31) 02-07-2016, 11:30 PM
Replies: 18
Views: 3,648
Posted By flintcamp
Re: Unknown part on Intake Manifold

I didn't realize some Model A's had vacuum wipers, thank you all, for the answer. I'll think I'll avoid installing a dilithium crystal injector though, it would seem the car could only be used on...
Forum: Model A (1928-31) 02-07-2016, 07:59 PM
Replies: 18
Views: 3,648
Posted By flintcamp
Unknown part on Intake Manifold

Looking through pictures of Model A engines on the internet some engines have a tube that runs from the intake manifold to the passenger side of the firewall below the gas tank. I was wondering if...
Showing results 1 to 8 of 8

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:12 PM.