Forum: Early V8
11-23-2023, 09:44 AM
|
Replies: 0
Views: 220
F 1 brakes
Shoes look like new. NO pitting backing plates. Drums fresh turned 11.040 after this picture.
|
Forum: Late V8
09-16-2023, 01:18 PM
|
Replies: 0
Views: 248
STEERING BOX. F200 or F250
Shipped to me by mistake. I don't own it. If you are interested I can give you the owner/sellers email. You can deal with him. Pick up only.
|
Forum: Early V8
09-14-2023, 09:48 PM
|
Replies: 0
Views: 280
|
Forum: Early V8
09-13-2023, 03:21 PM
|
Replies: 0
Views: 277
Rebuilt 59a engine
Looks like a Ford autherized rebuild. Full description on the other site. I can't cut and paste or type very good.
|
Forum: Early V8
07-28-2023, 04:25 PM
|
Replies: 0
Views: 154
1936 HUB/DRUM asy's. REAR
The drums measure TWELVE INCHES with NO grooves. Fins pitted but none broken. $350.00. plus shipping and a $50.00 handling charge.
|
Forum: Early V8
07-28-2023, 04:08 PM
|
Replies: 0
Views: 122
|
Forum: Early V8
07-28-2023, 03:57 PM
|
Replies: 0
Views: 214
8ba block
Purchased from RAYBEE in Kansas. Hot tanked. Pressure tested. Magnafluxed. 2 cracks headed for 2 cylinders. 1 cylinder gouged at least .060 deep. 1 exhaust port stiched up with Irontite plugs. He...
|
Forum: Early V8 (1932-53)
07-18-2023, 06:59 PM
|
Replies: 25
Views: 3,424
Re: 1936 1.5 ton transmission swap
Just posting to show off my C500. 5 speed trans. 2 speed electric rear end. 272 Y-Block. 55-60 M P H no problemo. Sorry. no picture. I don't understand Enter URL http// . Please inform me. Why...
|
Forum: Early V8 (1932-53)
07-18-2023, 06:40 PM
|
Replies: 24
Views: 9,182
Re: Conversion of Banjo Rear Axle to Modern Axles
Special side gears available exclusively from Wayne Atkinson. B S . Ford part # 5R3Z-4215-AA. I recently obtained a 201 QC with 19 spline side gears. They were cut down. Same as I had been cutting...
|
Forum: Early V8
07-13-2023, 04:42 PM
|
Replies: 0
Views: 368
WANTED; 35-36 2 door hump back body
FOUND. Extra nice body for very CHEAP. BUT shipping from NY to NC $1,400.00 but getting 2 36 rear ends and an 8BA block. To build a recreation of this very fast & very successful Wisconsin...
|
Forum: Early V8
06-03-2023, 09:22 AM
|
Replies: 0
Views: 413
Axle shafts
F O U N D ****Not sure what I need. I purchased a Halibrand 201 quickchange center section. I think it is N O S from 1950. The carrier is fitted with side gears to use slip in axles. They may have...
|
Forum: Early V8
05-23-2023, 10:18 AM
|
Replies: 0
Views: 330
|
Forum: Early V8
05-22-2023, 10:04 AM
|
Replies: 0
Views: 381
|
Forum: Early V8
05-15-2023, 03:46 PM
|
Replies: 0
Views: 415
|
Forum: Late V8
05-15-2023, 09:03 AM
|
Replies: 0
Views: 634
|
Forum: Early V8 (1932-53)
05-14-2023, 08:58 AM
|
Replies: 9
Views: 1,504
Re: Scam alert
Notice the rust in the cylinders. This scammer had this block an extreemly long time before he found a sucker. Me. Thanks Pete for the enlarged pictures.
|
Forum: Early V8 (1932-53)
05-14-2023, 08:26 AM
|
Replies: 16
Views: 1,806
Re: adj tappets 40 block
I posted a picture of my pin wrench on the HAMB because I don't know how this freakn' URL works on here.
|
Forum: Early V8 (1932-53)
05-14-2023, 08:20 AM
|
Replies: 10
Views: 1,246
Re: Try YRC Freight For Nationwide Parts Shipping
Y R C busted the block on a built 274 C I D flathead engine. $4,300.00. Semi must have been in a serious accident and engine went flying. They said they would pay .50 per pound for a used engine....
|
Forum: Early V8 (1932-53)
05-12-2023, 05:23 PM
|
Replies: 16
Views: 1,806
Re: adj tappets 40 block
I purchased a used but low mileage 274 C I D flathead. Valve lash was all over the place. No holes in the lifters bosses. What am I to do. Made this tool. Smooth end of a drill for the pins. Nice and...
|
Forum: Early V8 (1932-53)
05-12-2023, 04:57 PM
|
Replies: 16
Views: 1,806
Re: adj tappets 40 block
You are S O L if you purchased the lifters off the internet from that engine builder in Fresno CA. They are beyond TIGHT!. He says no one else has a problem. B S. He will take them back but he...
|
Forum: Early V8 (1932-53)
05-12-2023, 02:46 PM
|
Replies: 9
Views: 1,504
|
Forum: Early V8 (1932-53)
05-12-2023, 02:42 PM
|
Replies: 9
Views: 1,504
Scam alert
Ad says. 8BA block been hot tanked, pressure tested and magnafluxed. $500.00. Been magnafluxed alright but why didn't he say 2 cracks where found headed towards 2 cylinders? Why didn't he say a...
|
Forum: Late V8
05-09-2023, 04:08 PM
|
Replies: 0
Views: 682
ENGINE ADAPTER; 58-72- See text.
F O U N D. OFFENHAUSER # 0603. Lincoln 430 58-61, Edsel 58-59, Ford 332-428, and Mercury except 368, 58-72 to early Ford trans. THANK YOU.
|
Forum: Early V8
04-17-2023, 07:59 AM
|
Replies: 0
Views: 387
|
Forum: Early V8
04-16-2023, 08:40 AM
|
Replies: 0
Views: 296
|