Forum: Model A (1928-31)
11-09-2017, 10:13 PM
|
Replies: 19
Views: 4,179
Re: 1931 a truck
i also have same water pump in my 31 deluxe delivery has a bearing each end got it club flea market cant find any info would like to know who made it
|
Forum: Model A (1928-31)
10-02-2016, 02:06 PM
|
Replies: 5
Views: 2,124
|
Forum: Model A (1928-31)
10-01-2016, 07:16 PM
|
Replies: 5
Views: 2,124
t and a sprigs in hershey
cant get a hold of them phone not in service been at hershey for years are they still in business in ct
|
Forum: Model A (1928-31)
09-29-2016, 06:49 PM
|
Replies: 4
Views: 1,757
A and T springs CT
tried to phone number not in service any one heard if still in business they always at hershey thanks dave
|
Forum: Early V8 (1932-53)
05-18-2016, 08:21 PM
|
Replies: 2
Views: 1,203
46 ford fan loose on spindal
the 46 has fan noise with belt off has a litle movement on fan shaft any after market parts avaible still has oil in hub any help would be apreciated dave
|
Forum: Model A (1928-31)
12-11-2015, 09:53 AM
|
Replies: 6
Views: 1,590
|
Forum: Model A (1928-31)
12-10-2015, 08:04 PM
|
Replies: 6
Views: 1,590
V/8 clutch on non balanced engine
cant get vibration out from standard clutch on a non balenced engine pressure plate macs says 7 lbs off flywheel i have a lightined flywheel on other A has h/h touring engine they left a ridge on...
|
Forum: Early V8 (1932-53)
02-26-2015, 09:42 AM
|
Replies: 36
Views: 9,912
Re: Timing = heating?
Bubba was in hospital talked to has wife yesterday out now but has put all work has been on hold
|
Forum: Model A (1928-31)
11-07-2014, 08:45 PM
|
Replies: 22
Views: 6,791
|
Forum: Early V8 (1932-53)
08-05-2014, 07:40 PM
|
Replies: 1
Views: 815
wiring 46 ford risister to coil
changed motor from 8 ba to 59 a thought risister reduced voltage to coil but i get 6 vt both sides of risister green bible says .51 max ohms thats what my meter reads set at 1 k am i good to...
|
Forum: Model A (1928-31)
07-26-2014, 06:21 AM
|
Replies: 2
Views: 1,399
|
Forum: Model A (1928-31)
07-25-2014, 08:39 PM
|
Replies: 2
Views: 1,399
dif oll coming up speedo cagle
appears dif oil gets on speedo gear on drive shaft cable brings to dash then runs down valley under dash to floor where your foot is on gas peddel just starting to drive 31 deluxe delivery going to...
|
Forum: Early V8 (1932-53)
03-14-2013, 07:51 PM
|
Replies: 15
Views: 3,091
|
Forum: Model A (1928-31)
12-11-2012, 08:02 PM
|
Replies: 23
Views: 7,557
|
Forum: Model A (1928-31)
08-19-2012, 07:42 PM
|
Replies: 1
Views: 1,122
31deluxe delivery mfg
my 31 delivery has a small brass plate on the cowl the face is badly worn i think with a magnifying glass the name Y HENESEY and series of numbers below the name i thought murray or briggs were the...
|
Forum: Early V8 (1932-53)
03-26-2012, 07:59 PM
|
Replies: 6
Views: 1,758
Re: Hydraulic Brake Light Switch
i just replaced the brake light switch on my 46 to my suprise napa has 2 grads in stock went for the top grade 8.$works well im on silicone fluide
|
Forum: Early V8 (1932-53)
02-21-2012, 08:22 PM
|
Replies: 7
Views: 1,695
tread with 46 ford
my 46 ford conv. the front axle width at backing plats is aproxamatly 1in narrower than the the rear meaured at backing plates same results measuring width outside to outside of tires may wrong...
|
Forum: Model A (1928-31)
02-13-2012, 08:11 AM
|
Replies: 7
Views: 1,468
who made model a bodys
i know briggs and murrey four doors who made roadster coupe 2 door coach and pickups thanks dave
|
Forum: Model A (1928-31)
01-29-2012, 10:47 AM
|
Replies: 7
Views: 1,415
|
Forum: Model A (1928-31)
01-28-2012, 08:53 PM
|
Replies: 7
Views: 1,415
Re: 1931deluxe delivery produition numbers
thanks for the info as far as numbers remaining i only know of 3 yours amir in montreal and i just got one my self i hope the rear corner bracket you copied at hershey worked out....
|
Forum: Model A (1928-31)
01-28-2012, 07:16 AM
|
Replies: 7
Views: 1,415
|
Forum: Model A (1928-31)
01-27-2012, 08:58 PM
|
Replies: 7
Views: 1,415
|
Forum: Early V8 (1932-53)
12-17-2011, 09:32 PM
|
Replies: 11
Views: 2,090
generator over charging
my 46 with 8 ba charging rate at highway speedis high run with lights is normal had 8 volt battery now new 6volt lots of strength at start up new regulator same result any way of turning generator...
|
Forum: Early V8 (1932-53)
01-18-2011, 07:52 PM
|
Replies: 82
Views: 16,823
|
Forum: Early V8 (1932-53)
01-06-2011, 09:11 PM
|
Replies: 35
Views: 9,012
Re: Hard starting 53 flatty when hot
have same problem 46 ford 8 BA just worked on the car for 2 months would not start no fuel used vacum pump to get fuel to carb i think power valve leaks washes cylinders causing low compresion i...
|