Forum: Model A (1928-31)
01-08-2021, 09:22 PM
|
Replies: 21
Views: 3,615
Battery charger
Anyone have a recommendation for a good quality 6 volt battery charger?
And a good quality trickle charger?
Thanks in advance
Smurph
|
Forum: Model A (1928-31)
10-14-2019, 02:04 PM
|
Replies: 13
Views: 2,418
Re: Engine Noise
Thanks for your thoughts. I use MMO regularly in every gas fill up. I have also used a stethoscope which hasn’t helped much. Things sound pretty normal through the stethoscope when the “clacking”...
|
Forum: Model A (1928-31)
10-14-2019, 10:21 AM
|
Replies: 13
Views: 2,418
Engine Noise
My 1929 engine has developed a disturbing noise which I can best describe as a rattle, or a “clack, clack, clack” (not a clank). The noise usually does not occur at idle, but appears once revs...
|
Forum: Model A (1928-31)
04-09-2019, 04:23 PM
|
Replies: 11
Views: 2,306
Engine Knock Diagnostic Help Needed
I need some help from the FordBarn experts.
My 1929 “A” has developed an engine knock.
At idle I can hear a steady tapping of the valves which sound normal.
But, there is also a steady...
|
Forum: Model A (1928-31)
10-07-2018, 05:36 PM
|
Replies: 35
Views: 5,813
Re: Carburetor Float valves
Thanks for your replies. Still a mystery.
Main gas shut off valve working properly.
Put the float in container of gasoline— it floats, no sign of leaks.
Bob, thanks for the referral to Marco. I...
|
Forum: Model A (1928-31)
10-07-2018, 12:53 PM
|
Replies: 35
Views: 5,813
Re: Carburetor Float valves
HELP!
I’ve tried everything (?) and can’t stop carburetor leak. Carb has been functioning properly for 5 years. Then, all of a sudden, at a stop, after shutting off the main gas valve, gas drips out...
|
Forum: Model A (1928-31)
12-25-2014, 01:45 PM
|
Replies: 18
Views: 3,929
Re: Manifold Installation
Just finished this job. Ordered exhaust manifold from Bratton's (page 60, part # 13690). Very fine quality casting.
Instructions call for torquing to 45 pounds, a little at a time spacing the...
|
Forum: Model A (1928-31)
12-06-2014, 04:15 PM
|
Replies: 24
Views: 5,779
Re: Spark arrestor
The spark arrestor in my '29 Coupe was stuck tight. Would not budge even with proper tool nor with brute force! Put some Kroil around the rim a few times and let it soak some. Screwed right out!...
|
Forum: Model A (1928-31)
11-28-2014, 09:24 AM
|
Replies: 32
Views: 10,394
Re: Tricks to locate TDC
Bratton's sells an "Easy Timing Pin Key Ring" . Part #7891, on page 2 of 2014 parts catalog. $4.25.
It works well. Best to have 2 people, one to push car forward in third gear as the other feels...
|
Forum: Model A (1928-31)
11-17-2014, 01:49 PM
|
Replies: 16
Views: 4,089
Re: Diagnostic Help Needed
Thanks for your replies. Just for fun, and to highlight the flexibility of the English language, the "tap, tap, tap" noise occurs both at rest when revving up and at speed when tootling along....
|
Forum: Model A (1928-31)
11-16-2014, 12:33 PM
|
Replies: 16
Views: 4,089
Re: Diagnostic Help Needed
Thanks for your responses. I don't think I have a timing gear tooth/teeth problem. Car timed up really well and engine runs well.
I did check and clean the plugs. When I took them out they had a...
|
Forum: Model A (1928-31)
11-16-2014, 09:36 AM
|
Replies: 16
Views: 4,089
Diagnostic Help Needed
All of a sudden:
1) engine makes a "tap tap tap" noise when under acceleration, but not at idle or at speed-- only under acceleration;
2) on deceleration there are frequent backfires.
I assumed...
|
Forum: Early V8 (1932-53)
11-11-2014, 05:10 PM
|
Replies: 1
Views: 1,118
1935 Cabriolet--brake linings
I would like to replace the bonded brake linings with woven linings. Are there differences in the quality of the woven linings that various vendors sell? Can anyone recommend a vendor that has the...
|
Forum: Early V8 (1932-53)
10-26-2014, 11:13 AM
|
Replies: 8
Views: 1,990
1935 Cabriolet Problem--Poor Brakes
I purchased the restored car 2 years ago. From the outset the car didn't stop well. At slow speed I can lock the brakes. At 40-45 or going downhill they don't grab well at all.
I owned a Model A...
|
Forum: Model A (1928-31)
09-28-2014, 02:58 PM
|
Replies: 29
Views: 9,716
Re: gas stick
For a 10 gallon ('28-29) tank:
2 1/2" = 2.5 gallons = 1/4 tank
4 1/4" = 5.0 gallons = 1/2 tank
5 3/4" = 7.5 gallons = 3/4 tank
7 1/2" = 10 gallons = Full
|
Forum: Model A (1928-31)
08-14-2014, 05:32 PM
|
Replies: 5
Views: 1,951
Need Help Identifying 2 Tools
I'm looking for help ID'ing an Alemite grease gun and a spark plug/ head nut wrench. Been searching the forum with no results.
The Alemite grease gun is Model 6550. Lots of script on the barrel as...
|
Forum: Model A (1928-31)
06-25-2014, 09:57 PM
|
Replies: 19
Views: 6,418
|
Forum: Model A (1928-31)
06-23-2014, 06:23 PM
|
Replies: 4
Views: 1,227
|
Forum: Model A (1928-31)
06-23-2014, 05:35 PM
|
Replies: 4
Views: 1,227
Need help diagnosing generator / ammeter issue
I'm puzzled (as usual)!
12 Volt battery with voltage regulator.
Battery is draining down over time. Needed to recharge Sunday.
At startup and idle with battery fully charged, ammeter will not...
|
Forum: Early V8 (1932-53)
06-22-2014, 04:50 PM
|
Replies: 9
Views: 991
Generator Diagnosis Needed
I have a '35 Cabriolet converted to 12 Volt with a voltage regulator. Have not been getting a positive ammeter reading while running. Started up today and after a short ride and short rest tried to...
|
Forum: Model A (1928-31)
06-07-2014, 06:02 PM
|
Replies: 8
Views: 4,434
|
Forum: Model A (1928-31)
05-30-2014, 09:24 AM
|
Replies: 13
Views: 3,410
|
Forum: Model A (1928-31)
04-24-2014, 06:10 PM
|
Replies: 3
Views: 1,608
|
Forum: Model A (1928-31)
04-24-2014, 06:08 PM
|
Replies: 3
Views: 1,608
|
Forum: Model A (1928-31)
04-24-2014, 06:06 PM
|
Replies: 3
Views: 1,608
Can anyone help ID this body number?
I have a 1929 Standard Coupe, engine # *A2127872* which was made on August 13, 1929. The firewall has a date stamp of August 6, 1929. The generator band is stamped 8J for August 1929 and the...
|