Forum: Model A (1928-31)
02-09-2022, 06:41 PM
|
Replies: 22
Views: 1,660
Re: Model AA cyclinder compression
have reset the timing with a timing wrench that i have used previously on the Coupe (that hadnt run in 10 yrs) then it started right up with basic tuneup.
the simplicity of them is what makes it so...
|
Forum: Model A (1928-31)
02-09-2022, 06:38 PM
|
Replies: 22
Views: 1,660
Re: Model AA cyclinder compression
we looked at that: the ammeter does not wiggle., so prob bad. however, it is passing power between the 2 terminals as we are getting power "downstream". i have an old one i can put in but point well...
|
Forum: Model A (1928-31)
02-09-2022, 05:06 PM
|
Replies: 22
Views: 1,660
|
Forum: Model A (1928-31)
02-09-2022, 04:52 PM
|
Replies: 22
Views: 1,660
Re: Model AA cyclinder compression
It woudlnt start so i started changing one thing at a time. The ignition switch had gotten real lucy-goosy when you turned key off it kept running or you could pull the key out so i changed that...
|
Forum: Model A (1928-31)
02-09-2022, 04:37 PM
|
Replies: 22
Views: 1,660
Re: Model AA cyclinder compression
yep, got gas, even drips out if i choke it too much. Yeah, i keep thinking/hoping its something simple but its not giving in that easy!
|
Forum: Model A (1928-31)
02-09-2022, 03:57 PM
|
Replies: 22
Views: 1,660
Model AA cyclinder compression
This old truck has ALWAYS started. But not now. I have replaced all plugs, points, condenser, starter switch, set timing, etc.... all the usual. Getting spark, gas, ckd wiring connections. Now i...
|
Forum: Model-A
06-14-2019, 07:58 AM
|
Replies: 0
Views: 1,174
Tillitson carb
Tillitson Carb needed....mainly just the top 1/2 or the whole thing.
|
Forum: Model A (1928-31)
03-29-2016, 04:05 PM
|
Replies: 11
Views: 2,275
|
Forum: Model A (1928-31)
03-29-2016, 03:44 PM
|
Replies: 11
Views: 2,275
Re: Transmission issue
Thanks for the helpful hints.
I have a 30AA and have found that 2sides of the shifter are dround flat. But I don't see any logical way to get it out but to remove the 3 "shifting rods" that are...
|
Forum: Model A (1928-31)
02-23-2016, 01:40 PM
|
Replies: 39
Views: 22,855
|
Forum: Model A (1928-31)
02-23-2016, 11:39 AM
|
Replies: 39
Views: 22,855
Re: Transmission Fluid Change Procedure
Since I have you, I'm changing the trans fluid first time. Can I flush to clean with diesel since I don't have a source for kerosine? Or just put the new 600w in with a splash of STP?
Thx
|
Forum: Model A (1928-31)
02-23-2016, 11:39 AM
|
Replies: 39
Views: 22,855
Re: Transmission Fluid Change Procedure
Since I have you, I'm changing the trans fluid first time. Can I flush to clean with diesel since I don't have a source for kerosine? Or just put the new 600w in with a splash of STP?
Thx
|
Forum: Model A (1928-31)
02-23-2016, 11:36 AM
|
Replies: 39
Views: 22,855
|
Forum: Model A (1928-31)
02-23-2016, 11:24 AM
|
Replies: 39
Views: 22,855
Re: Transmission Fluid Change Procedure
I know this is an old post of the picture with the vent hole...... But...... I've got a '30 AA truck and there is no vent hole anywhere on the tower base, is there a different place on the AA?
|
Forum: Model A (1928-31)
02-23-2016, 08:39 AM
|
Replies: 17
Views: 5,265
|