Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 74
Search took 0.01 seconds.
Search: Posts Made By: Ford1930
Forum: Model A (1928-31) 07-16-2020, 01:21 PM
Replies: 13
Views: 773
Posted By Ford1930
Re: Coil problem?

Hi Model A Friends!

Thank You all for the help. Yesterday my 1929 Phaeton started finaly. The problem was not the Coil. It was a mix of bad timing and incorrect connected wires to the AM meter....
Forum: Model A (1928-31) 07-11-2020, 12:45 PM
Replies: 13
Views: 773
Posted By Ford1930
Coil problem?

I am still trying to get my 1929 Phaeton to start. I replaced almost all ignition parts: upper- and lowerplate, points, Armored cable, ignitionlock, condensor and coil.
When I measure the Coil I...
Forum: Model A (1928-31) 06-23-2020, 07:33 AM
Replies: 11
Views: 435
Posted By Ford1930
Re: No Voltage on Ignition 1929 Phaeton

I have found the problem (I hope) The Armored Wire seems to be the problem. I am going to replace it by a new one. I'll replace the switch at the same time.
Thank You All for the HELP!!!
Forum: Model A (1928-31) 06-20-2020, 01:04 PM
Replies: 11
Views: 435
Posted By Ford1930
Re: No Voltage on Ignition 1929 Phaeton

I have a Modern Upper and Lower Plate. Cordless connection.
How far may an Armored Wire be screwed in? I can see a few millimeters of the treaded end when I look in the distributor.
Forum: Model A (1928-31) 06-20-2020, 12:11 PM
Replies: 11
Views: 435
Posted By Ford1930
No Voltage on Ignition 1929 Phaeton

I need help. If haven't got voltage on the points in my 1929 35A. I have renewed the upper and lower Ignition Plates and the Points (Nu Rex). I have checked the newly installed Coil and the Ignition...
Forum: Model A (1928-31) 05-17-2020, 09:49 AM
Replies: 3
Views: 340
Posted By Ford1930
1929 Phaeton Tie Rod installation.

Thanks to this great Forum I managed to remove the old Tie Rod.
The new challenge is the i stallation of the new Tie Rod. I already had a go ar ir, but failed to get the ends over the “balls”. The...
Forum: Model A (1928-31) 05-10-2020, 07:39 AM
Replies: 1
Views: 269
Posted By Ford1930
1929 Tie Rod removal

What is the best way to remove the Tie Rod (Ends) from the Tie Rod Balls? I have removed the screws in the Tie Rod Ends. Any suggestion welcome!
Forum: Model A (1928-31) 03-12-2020, 03:58 PM
Replies: 25
Views: 1,952
Posted By Ford1930
Re: Shortened Pitman Arm

Some pictures of the Normal Pitman Arm and the Shortened one.
It is an Ford Official Licensed Product.
Forum: Model A (1928-31) 03-10-2020, 01:05 PM
Replies: 25
Views: 1,952
Posted By Ford1930
Re: Shortened Pitman Arm

I tried to upload a picture of my 35A in the "Quick Reply". Probably didn't work....
So another attempt.
Forum: Model A (1928-31) 03-10-2020, 01:02 PM
Replies: 25
Views: 1,952
Posted By Ford1930
Re: Shortened Pitman Arm

I am glad with everything I read about my questions. I just ordered a Shortened Pitman Arm.
It will be installed in my 1929Phaetonhttp:///Users/dbrussee/Desktop/IMG_3347 kopie.jpg
Thank You ALL for...
Forum: Model A (1928-31) 03-10-2020, 03:57 AM
Replies: 25
Views: 1,952
Posted By Ford1930
Shortened Pitman Arm

I am looking for information on the use of the shortened Pitman Arm.
Is it a intelligent thing to install this arm in place of the original? Does it need other changes? Can one still use the...
Forum: Model A (1928-31) 11-08-2018, 01:02 PM
Replies: 6
Views: 1,173
Posted By Ford1930
Re: How to replace the intake manifold

Thanks everybody for the help! I have decided to renew both intake- and exhaust manifold including gaskets, washers and nuts.
Forum: Model A (1928-31) 11-04-2018, 02:49 PM
Replies: 6
Views: 1,173
Posted By Ford1930
How to replace the intake manifold

Due to a crack in the old one, I need to replace the intake manifold. What is the best way to do it? I am planning to renew the gaskets. What is the best gasket to order? Do I need to buy Model A...
Forum: Model A (1928-31) 09-04-2018, 01:17 PM
Replies: 11
Views: 1,439
Posted By Ford1930
Re: Dropping the oil Pan

My 1929 Phaeton comes out of a Museum and was idle for quite some time. I pulled the dipstick and found good oil, no water in it. I didn't drain the pan yet. But in case there is much sludge I would...
Forum: Model A (1928-31) 09-03-2018, 04:25 PM
Replies: 11
Views: 1,439
Posted By Ford1930
Dropping the oil Pan

Hello ALL, what do I need to know when I drop the Oil Pan with the Engine still in place? What do I have to take in Mind and use?
Forum: Model A (1928-31) 08-20-2018, 04:01 AM
Replies: 20
Views: 2,662
Posted By Ford1930
How to attach a Turn Signal Flasher

I would like to read your views and experiences about the place and the way to attach the 6 Volt Turn Signal Flasher(3 Sprong Type) from Mac's. It has no mounting.
Forum: Model A (1928-31) 06-15-2018, 12:08 PM
Replies: 7
Views: 1,748
Posted By Ford1930
Re: Wind Wing Tension Washer

Thank you for the advice. I haven't had problems yet. Haven't driven my 1929 Phaeton yet. Just saw these tension washer and was curious about the fitting and effect.
Forum: Model A (1928-31) 06-01-2018, 01:00 PM
Replies: 7
Views: 1,748
Posted By Ford1930
Wind Wing Tension Washer

What is your experience with the Wind Wing Tension Washer? How is it placed correctly? Please some advise.
Forum: Model A (1928-31) 05-06-2018, 08:42 AM
Replies: 4
Views: 819
Posted By Ford1930
Re: Wheels in "Stripe - Color"

Thank you all for the info. It matches my feelings that Henry started with the introduction of the "Deluxe" models in 1930. I'll keep the wheels on my 1929 Phaeton Black!
Forum: Model A (1928-31) 05-05-2018, 02:03 PM
Replies: 4
Views: 819
Posted By Ford1930
Wheels in "Stripe - Color"

When did Henry Ford start offering Wheels in the Color of the Stripe? 1928?
Forum: Model A (1928-31) 05-03-2018, 09:10 AM
Replies: 0
Views: 393
Posted By Ford1930
Any other 1929 Balsam Green Phaetons around?

I would like to see pictures of 1929 Phaetons in the Colors: Balsam Green (Body) Valley Green (Belt etc.) and Medium Cream (Stripe).
The picture shows the one I own.
Forum: Model A (1928-31) 05-02-2018, 01:22 AM
Replies: 8
Views: 1,748
Posted By Ford1930
Re: 1929 Cowl Lacing

Great, thanks for the help!
Forum: Model A (1928-31) 04-30-2018, 03:17 PM
Replies: 8
Views: 1,748
Posted By Ford1930
Re: 1929 Cowl Lacing

Is there a picture of the "J Hook" installed?
Forum: Model A (1928-31) 04-30-2018, 01:08 PM
Replies: 8
Views: 1,748
Posted By Ford1930
Re: 1929 Cowl Lacing

Thank you very much for the pictures!
Forum: Model A (1928-31) 04-25-2018, 11:38 AM
Replies: 8
Views: 1,748
Posted By Ford1930
1929 Cowl Lacing

The Cowl Lacing of my early 1929 Phaeton was gone at the time I bought Henry's Lady. Can anyone tell me what the correct way is to install new? I ordered new from Mac's. Pictures showing how it...
Showing results 1 to 25 of 74

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:43 PM.