Forum: Model A (1928-31)
07-28-2021, 02:18 PM
|
Replies: 9
Views: 1,158
Re: Drum Tail Light
As advised I made a temporary ground wire. It works. The problem is a bad ground on the right drum tail light!
Thank You ALL for the HELP!
|
Forum: Model A (1928-31)
07-28-2021, 08:55 AM
|
Replies: 9
Views: 1,158
Re: Drum Tail Light
I made pictures of the drum tail lights when the Brake Pedal is depressed.
The Left Brake Light "burns". The Right Brake light is OFF. Instead the Right Taillight "burns" weakly. What may be the...
|
Forum: Model A (1928-31)
07-28-2021, 04:49 AM
|
Replies: 9
Views: 1,158
Drum Tail Light
I would like to see an "explosion" drawing of the Drum Tail Light.
When I press the brake pedal the left brake light works. The right one does not work. In stead the right light (below in the drum)...
|
Forum: Model A (1928-31)
07-18-2021, 03:39 PM
|
Replies: 3
Views: 911
|
Forum: Model A (1928-31)
07-18-2021, 01:28 PM
|
Replies: 3
Views: 911
Flat battery ground strap
Can someone tell me how the flat battery ground strap is attached to the chassis and battery? Pictures are most welcome!
|
Forum: Model A (1928-31)
10-25-2020, 05:20 AM
|
Replies: 11
Views: 2,479
|
Forum: Model A (1928-31)
10-24-2020, 01:45 AM
|
Replies: 11
Views: 2,479
1929 tailpipe clamp picture
I would like to see a picture of the 1929 tail pipe clamp fitted to a 1929 Model A. Who can supply one? I am not familiar with the correct way to mount it.
|
Forum: Model A (1928-31)
10-09-2020, 03:35 PM
|
Replies: 9
Views: 1,776
|
Forum: Model A (1928-31)
07-16-2020, 01:21 PM
|
Replies: 13
Views: 1,936
Re: Coil problem?
Hi Model A Friends!
Thank You all for the help. Yesterday my 1929 Phaeton started finaly. The problem was not the Coil. It was a mix of bad timing and incorrect connected wires to the AM meter....
|
Forum: Model A (1928-31)
07-11-2020, 12:45 PM
|
Replies: 13
Views: 1,936
Coil problem?
I am still trying to get my 1929 Phaeton to start. I replaced almost all ignition parts: upper- and lowerplate, points, Armored cable, ignitionlock, condensor and coil.
When I measure the Coil I...
|
Forum: Model A (1928-31)
06-23-2020, 07:33 AM
|
Replies: 11
Views: 1,426
Re: No Voltage on Ignition 1929 Phaeton
I have found the problem (I hope) The Armored Wire seems to be the problem. I am going to replace it by a new one. I'll replace the switch at the same time.
Thank You All for the HELP!!!
|
Forum: Model A (1928-31)
06-20-2020, 01:04 PM
|
Replies: 11
Views: 1,426
Re: No Voltage on Ignition 1929 Phaeton
I have a Modern Upper and Lower Plate. Cordless connection.
How far may an Armored Wire be screwed in? I can see a few millimeters of the treaded end when I look in the distributor.
|
Forum: Model A (1928-31)
06-20-2020, 12:11 PM
|
Replies: 11
Views: 1,426
No Voltage on Ignition 1929 Phaeton
I need help. If haven't got voltage on the points in my 1929 35A. I have renewed the upper and lower Ignition Plates and the Points (Nu Rex). I have checked the newly installed Coil and the Ignition...
|
Forum: Model A (1928-31)
05-17-2020, 09:49 AM
|
Replies: 3
Views: 1,098
1929 Phaeton Tie Rod installation.
Thanks to this great Forum I managed to remove the old Tie Rod.
The new challenge is the i stallation of the new Tie Rod. I already had a go ar ir, but failed to get the ends over the “balls”. The...
|
Forum: Model A (1928-31)
05-10-2020, 07:39 AM
|
Replies: 1
Views: 1,121
1929 Tie Rod removal
What is the best way to remove the Tie Rod (Ends) from the Tie Rod Balls? I have removed the screws in the Tie Rod Ends. Any suggestion welcome!
|
Forum: Model A (1928-31)
03-12-2020, 03:58 PM
|
Replies: 25
Views: 4,146
Re: Shortened Pitman Arm
Some pictures of the Normal Pitman Arm and the Shortened one.
It is an Ford Official Licensed Product.
|
Forum: Model A (1928-31)
03-10-2020, 01:05 PM
|
Replies: 25
Views: 4,146
Re: Shortened Pitman Arm
I tried to upload a picture of my 35A in the "Quick Reply". Probably didn't work....
So another attempt.
|
Forum: Model A (1928-31)
03-10-2020, 01:02 PM
|
Replies: 25
Views: 4,146
Re: Shortened Pitman Arm
I am glad with everything I read about my questions. I just ordered a Shortened Pitman Arm.
It will be installed in my 1929Phaetonhttp:///Users/dbrussee/Desktop/IMG_3347 kopie.jpg
Thank You ALL for...
|
Forum: Model A (1928-31)
03-10-2020, 03:57 AM
|
Replies: 25
Views: 4,146
Shortened Pitman Arm
I am looking for information on the use of the shortened Pitman Arm.
Is it a intelligent thing to install this arm in place of the original? Does it need other changes? Can one still use the...
|
Forum: Model A (1928-31)
11-08-2018, 01:02 PM
|
Replies: 6
Views: 2,293
|
Forum: Model A (1928-31)
11-04-2018, 02:49 PM
|
Replies: 6
Views: 2,293
How to replace the intake manifold
Due to a crack in the old one, I need to replace the intake manifold. What is the best way to do it? I am planning to renew the gaskets. What is the best gasket to order? Do I need to buy Model A...
|
Forum: Model A (1928-31)
09-04-2018, 01:17 PM
|
Replies: 11
Views: 2,978
Re: Dropping the oil Pan
My 1929 Phaeton comes out of a Museum and was idle for quite some time. I pulled the dipstick and found good oil, no water in it. I didn't drain the pan yet. But in case there is much sludge I would...
|
Forum: Model A (1928-31)
09-03-2018, 04:25 PM
|
Replies: 11
Views: 2,978
Dropping the oil Pan
Hello ALL, what do I need to know when I drop the Oil Pan with the Engine still in place? What do I have to take in Mind and use?
|
Forum: Model A (1928-31)
08-20-2018, 04:01 AM
|
Replies: 20
Views: 4,521
How to attach a Turn Signal Flasher
I would like to read your views and experiences about the place and the way to attach the 6 Volt Turn Signal Flasher(3 Sprong Type) from Mac's. It has no mounting.
|
Forum: Model A (1928-31)
06-15-2018, 12:08 PM
|
Replies: 7
Views: 2,740
Re: Wind Wing Tension Washer
Thank you for the advice. I haven't had problems yet. Haven't driven my 1929 Phaeton yet. Just saw these tension washer and was curious about the fitting and effect.
|