Forum: Early V8 (1932-53)
Today, 11:16 AM
|
Replies: 18
Views: 653
Re: 1935 Coupe help
If it was me I would go over this car with a fine tooth comb, I would be looking for rust in the floor pan and check the panel below the trunk and behind the spare tire panel. The panel is very prone...
|
Forum: Early V8 (1932-53)
Today, 11:04 AM
|
Replies: 10
Views: 424
|
Forum: Early V8 (1932-53)
Yesterday, 11:31 AM
|
Replies: 18
Views: 653
Re: 1935 Coupe help
Obviously has the wrong heater in it. The frame # is on the top of the left frame rail near the steering box. should compare with the # on the ownership certificate.
|
Forum: Early V8 (1932-53)
03-23-2024, 10:35 AM
|
Replies: 8
Views: 569
|
Forum: Early V8 (1932-53)
03-23-2024, 10:33 AM
|
Replies: 2
Views: 239
Re: my '37 fordor does have the cowl drain
If you ran the hoses from the windshield into the cowl you need to make sure the water can drain out of the cowl panel. There is a drain nipple in each lower corner of the windshield opening.
|
Forum: Early V8 (1932-53)
03-19-2024, 10:10 AM
|
Replies: 21
Views: 1,136
|
Forum: Early V8 (1932-53)
03-19-2024, 09:58 AM
|
Replies: 5
Views: 214
|
Forum: Early V8 (1932-53)
03-19-2024, 09:54 AM
|
Replies: 2
Views: 154
|
Forum: Early V8 (1932-53)
03-18-2024, 07:33 PM
|
Replies: 9
Views: 431
Re: Lake pipes
O.K. what length do you want? Do you want them to run the full length of the lower rocker panel? Or do you want some other length? Everybody is different and you need to look at what is pleasing to...
|
Forum: Early V8 (1932-53)
03-18-2024, 09:59 AM
|
Replies: 9
Views: 431
Re: Lake pipes
As I recall I used the 60 inch ones from Speedway on my 54 Merc. The ones from speedway were excellent quality.
|
Forum: Early V8 (1932-53)
03-17-2024, 04:03 PM
|
Replies: 20
Views: 798
|
Forum: Early V8 (1932-53)
03-17-2024, 01:20 PM
|
Replies: 20
Views: 798
|
Forum: Early V8 (1932-53)
03-17-2024, 10:14 AM
|
Replies: 20
Views: 745
|
Forum: Early V8 (1932-53)
03-17-2024, 10:11 AM
|
Replies: 22
Views: 1,056
Re: Still sober
Craig, good for you and I'm sure your family is proud of you.
|
Forum: Early V8 (1932-53)
03-17-2024, 10:05 AM
|
Replies: 20
Views: 798
|
Forum: Early V8 (1932-53)
03-16-2024, 12:42 PM
|
Replies: 5
Views: 380
Re: Vacuum Leak
Hopefully it's a good strong rubber plug with a good flange on it. If not there is a potential for vacuum to pull it into the motor. Living in Willows you should have an auto parts store or Ace...
|
Forum: Early V8 (1932-53)
03-16-2024, 10:04 AM
|
Replies: 8
Views: 558
|
Forum: Early V8 (1932-53)
03-15-2024, 11:36 AM
|
Replies: 1
Views: 181
|
Forum: Early V8 (1932-53)
03-14-2024, 10:24 AM
|
Replies: 5
Views: 281
Re: Front window drainage - 37
Make sure the bottom of the cowl has a clean outlet for the water. If the windshield drains were plugged you can bet the cowl is also plugged.
|
Forum: Early V8 (1932-53)
03-14-2024, 10:20 AM
|
Replies: 6
Views: 387
Re: 32 3 window seat
Some springs have a metal tab attached to the outer rim of the seat spring. There are normally 4 of those tabs (two top and two bottom). The tabs have a hole in them for a small screw to go into the...
|
Forum: Early V8 (1932-53)
03-14-2024, 10:06 AM
|
Replies: 6
Views: 381
|
Forum: Early V8 (1932-53)
03-13-2024, 09:34 AM
|
Replies: 5
Views: 324
Re: adds
David has the answer. I never sign out and never get the ads.
|
Forum: Early V8 (1932-53)
03-12-2024, 09:35 AM
|
Replies: 6
Views: 381
|
Forum: Early V8
03-11-2024, 04:30 PM
|
Replies: 0
Views: 99
governor for big Ford Truck
Governor for a big Ford truck. Definitely from the flathead era. Has a brass Ford Company tag riveted on the side part # 40-6850-C1 . Made by the Monarch Governor Co. $50 plus shipping. It should fit...
|
Forum: Early V8 (1932-53)
03-10-2024, 07:35 PM
|
Replies: 11
Views: 753
|