Forum: Early V8 (1932-53)
10-10-2014, 05:14 PM
|
Replies: 4
Views: 1,347
|
Forum: Early V8 (1932-53)
10-10-2014, 05:10 PM
|
Replies: 15
Views: 2,056
Re: Front wheel bearing question
Timken has provided bearings from all over the world for at least 25 years that I know of. In fact their boxes used to say, " could be made in one of the following countries." Then they would list...
|
Forum: Early V8 (1932-53)
05-10-2014, 04:46 PM
|
Replies: 5
Views: 2,279
Re: Bearing ID
You could try a NAPA Distributor. They are Federal Mogul engine bearing Distributors. They can give f.M the McQuay part number and F.M. should be able to interchange the part numbers and tell you...
|
Forum: Early V8 (1932-53)
04-26-2014, 06:32 PM
|
Replies: 30
Views: 8,409
Re: Clutch Chatter
For what it's worth. Back in the forties and fifties when my cronies and I were running the thirties and forties Fords, we would all have the same problem in first gear. Ninety percent of the time it...
|
Forum: Early V8 (1932-53)
04-15-2014, 06:30 PM
|
Replies: 14
Views: 2,924
Re: putting gas tank hose on filler neck
I had the same problem on my '48 Merc. I finally took a pair of in and out calipers and measured the pipe o.d. and the hose i.d. There is no way they would fit. I contacted the Old Ford Distributor...
|
Forum: Early V8 (1932-53)
04-13-2014, 05:15 PM
|
Replies: 20
Views: 6,063
Re: 48' mercury convertible
Looks real good from where I sit! Sure worth saving. Jim TM is correct too. To the left of the Voltage Reg. is one of the Columbia controls that the Speedo cables go through. I don't see the vac/elec...
|
Forum: Early V8 (1932-53)
04-13-2014, 05:03 PM
|
Replies: 35
Views: 9,597
|
Forum: Early V8 (1932-53)
04-10-2014, 08:59 PM
|
Replies: 10
Views: 2,169
Re: Wipers don't work
About five years ago had the same problem on my '48. Started checking some Ford sites and I can't remember which one but it said to shoot a small amount of ATF into the intake side. Worked like a...
|
Forum: Early V8 (1932-53)
04-08-2014, 07:22 PM
|
Replies: 20
Views: 6,063
Re: 48' mercury convertible
My '48 that I just sold was black and looked like the one that '47 Merc. posted except the interior was maroon and gray and had every option available. Including Columbia rear it also had dual...
|
Forum: Early V8 (1932-53)
04-07-2014, 06:05 PM
|
Replies: 20
Views: 6,063
Re: 48' mercury convertible
I just sold mine. The fella I sold it to is a '46-'48 Merc. Guru. He's got em. He is located in Ok. If you want info. feel free to email me at [email protected]. I can also give you his name...
|
Forum: Early V8 (1932-53)
02-25-2014, 06:36 PM
|
Replies: 20
Views: 13,668
Re: Flathead hard start when hot
I grew up with "flatties." They were the most dependable engines on the road. Always started on half a revolution hot or cold, covered with snow or water. My Dad never had one overheat and never, no...
|
Forum: Early V8 (1932-53)
01-13-2014, 05:12 PM
|
Replies: 12
Views: 2,181
Re: '48 coupe heater hose connection question
Hey Bolts, It kicked me off again !!! i've never had to jack up the engine or move the radiator! If you want to know how I do it. Call me. 631-728-0119. I hope this goes through to you!
rich O.
|
Forum: Early V8 (1932-53)
01-11-2014, 11:25 AM
|
Replies: 12
Views: 2,181
|
Forum: Early V8 (1932-53)
01-04-2014, 06:34 PM
|
Replies: 12
Views: 2,181
Re: '48 coupe heater hose connection question
Tried to send you my lengthy procedure but as usual my reply did not show up and although I was logged on I was informed that I was not, so hopefully some other barners have replied to your request....
|
Forum: Early V8 (1932-53)
12-05-2013, 05:29 PM
|
Replies: 95
Views: 18,172
|
Forum: Early V8 (1932-53)
11-10-2013, 10:21 AM
|
Replies: 12
Views: 2,406
Re: Flooding carb
I know this has been discussed over and over but I will add my two cents only as some information from my experience. I had replaced the carb four times on my Merc. only to find out that the flooding...
|
Forum: Early V8 (1932-53)
11-10-2013, 09:56 AM
|
Replies: 40
Views: 19,391
Re: Make your ethanol-free gas!
Boy, sounds like a can of worms! I don't know about other states but here in N.Y. State, ( land of taxes and regulations ) I've gone to my local Marinas to purchase non ethanol, Nope, NYS has now...
|
Forum: Early V8 (1932-53)
11-07-2013, 06:31 PM
|
Replies: 23
Views: 4,310
Re: moisture in cap again
Most good auto parts stores or marine supply or marinas will stock CRC. You could probably find it in an Overton's Marine Supply Catalog. Overton's is a Nationwide supplier and their headquarters is...
|
Forum: Early V8 (1932-53)
11-06-2013, 06:11 PM
|
Replies: 23
Views: 4,310
Re: moisture in cap again
No one has mentioned CRC Marine ( green can ) I've had numerous boats used in salt water. Always sprayed ignition and all electronic connections with CRC, that is what it is designed for. Never had a...
|
Forum: Early V8 (1932-53)
10-21-2013, 05:20 PM
|
Replies: 4
Views: 1,754
|
Forum: Early V8 (1932-53)
09-25-2013, 06:48 PM
|
Replies: 42
Views: 15,543
Re: Help, Rear Brake Drum Removal
Van Pelt Sales (on here the Ford Barn)rents the KR puller. I rented mine from them a few months ago. Worth the price!!
Of course if you plan on removing your drums on a regular basis, I guess it's...
|
Forum: Early V8 (1932-53)
09-11-2013, 06:59 PM
|
Replies: 30
Views: 6,751
|
Forum: Early V8 (1932-53)
07-13-2013, 07:48 PM
|
Replies: 3
Views: 1,392
|
Forum: Late V8 (1954+)
07-11-2013, 07:13 PM
|
Replies: 4
Views: 1,698
Shipping question
Hi all, a gentleman from British Columbia is interested in purchasing my '48 Mercury convertible. He is searching out the procedure ( customs and all) and the most economical, safest way to ship it...
|
Forum: Early V8 (1932-53)
07-11-2013, 07:07 PM
|
Replies: 3
Views: 1,392
Shipping question
A gentleman from British Columbia is interested in purchasing my '48 Mercury convertible. He is trying to find the procedure and most economical way to ship the car from Eastern Long Island in the...
|