Forum: Early V8 (1932-53)
02-09-2021, 10:10 AM
|
Replies: 42
Views: 1,926
|
Forum: Early V8 (1932-53)
01-22-2021, 03:03 AM
|
Replies: 6
Views: 575
|
Forum: Early V8 (1932-53)
01-02-2021, 04:17 AM
|
Replies: 14
Views: 612
Re: Adapting An OE Gas Tank Sender Unit
Be careful, on my tudor 37 I made a rubber gasket between the sending unit and the tank. Some days later it was smelling gas in the car... the rubber was melt by gasoline...
|
Forum: Early V8 (1932-53)
11-23-2020, 03:44 AM
|
Replies: 15
Views: 802
Re: Temperature
Kevin, I think like Alan; your stats are operating correctly!
mine are 160°F so they are closed until the temperature is 160°F; at this temperature they open and let the coolant circulate so the...
|
Forum: Early V8 (1932-53)
11-18-2020, 02:12 AM
|
Replies: 12
Views: 897
Re: 1936 radiator petcock
Yes it's very difficult to solder a radiator because the two boxes (top & bottom) are tin soldered, so if you heat too much the result will be leaks.
feufeu.
|
Forum: Early V8 (1932-53)
11-16-2020, 05:41 AM
|
Replies: 12
Views: 897
Re: 1936 radiator petcock
I had the same issueon my 37 radiator. wanted to replace the petcok and i broke it.
So i drilled a hole of 18mm in the radiator, and put in the hole a brass part I made. The internal of the part...
|
Forum: Early V8 (1932-53)
11-14-2020, 08:02 AM
|
Replies: 19
Views: 1,064
|
Forum: Early V8 (1932-53)
11-14-2020, 04:22 AM
|
Replies: 8
Views: 1,064
|
Forum: Early V8 (1932-53)
10-16-2020, 12:41 PM
|
Replies: 16
Views: 1,040
|
Forum: Early V8 (1932-53)
10-16-2020, 12:37 PM
|
Replies: 16
Views: 1,040
Re: connector sleeve for choke rod
Hi Tom, in my 37 there is a piece connecting the two parts of the rod. You can see it in the red circles on the picture (picture under dash).
Sorry for my english, i'm french!
I couldnt...
|