Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: burly
Forum: Early V8 (1932-53) 09-06-2016, 11:57 AM
Replies: 27
Views: 5,556
Posted By burly
Re: No oil pressure

Well guys no grub screw was present. Poured oil down the middle outlet hole, removed spark plugs and spun it over and it went to forcing oil right back out. Installed the spark plugs and re-attached...
Forum: Early V8 (1932-53) 09-06-2016, 09:11 AM
Replies: 27
Views: 5,556
Posted By burly
Re: No oil pressure

You're right Ronnie. My bad! What I should have said originally was that "I didn't have it machined for 95% flow" but after I described what I had and after reading some of the responses folks were...
Forum: Early V8 (1932-53) 09-04-2016, 11:23 AM
Replies: 27
Views: 5,556
Posted By burly
Re: No oil pressure

Thanks guys. I figured this new engine had these 3 holes from the factory? I didn't have it machined to have the 95% oil filtering system but maybe Ford did? I just know it has 3 holes where the...
Forum: Early V8 (1932-53) 09-04-2016, 07:11 AM
Replies: 27
Views: 5,556
Posted By burly
Re: No oil pressure

This one does have the 3 outlet holes. Horizontal. then the vertical for oil pressure sending unit then the top one in the bell housing. Sound like I need to either remove the plug from the...
Forum: Early V8 (1932-53) 09-03-2016, 08:20 PM
Replies: 27
Views: 5,556
Posted By burly
No oil pressure

Recently installed a freshened up early Canadian flathead. Ran a mechanical gauge to where the original mushroom type electronic oil sending switch would have been installed and plugged the other 2...
Showing results 1 to 5 of 5

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:27 PM.