Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 9 of 9
Search took 0.00 seconds. Search: Posts Made By: Jeff M
Forum: Model A (1928-31) 03-27-2023, 09:48 AM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

I actually tried that but it’s still too tight of a fit.
Forum: Model A (1928-31) 03-26-2023, 05:43 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

Everything went smooth until the four inside rivets on top of the lower frame rail. You can’t drill these so I figured I could grind the heads off and knock them out. Wouldn’t budge even with an air...
Forum: Model A (1928-31) 03-16-2023, 09:24 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

Interesting, my frame has no engine or trans in so hopefully it’ll be good.
Forum: Model A (1928-31) 03-15-2023, 01:39 AM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

Thank you
Forum: Model A (1928-31) 03-14-2023, 02:40 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

Finally took my body off so it’s time to drill. A poster above said the shank is 3/16” so do I need to use a 5/32” bit? The rivet head is 7/16”.
Forum: Model A (1928-31) 12-29-2022, 04:11 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

I meant welding some steel across the frame to make sure the frame doesn’t move while removing the center crossmember.
Forum: Model A (1928-31) 12-29-2022, 11:48 AM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

So no bracing is necessary for the center crossmember? I guess that’s only required for removing the front or rear crossmember since it obviously would free the frame rails.
Forum: Model A (1928-31) 12-28-2022, 07:35 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Re: Removing center crossmember

Thanks for the tips!
Forum: Model A (1928-31) 12-27-2022, 10:23 PM
Replies: 22
Views: 2,824
Posted By Jeff M
Removing center crossmember

I need to remove and replace my center crossmember on my 30 coupe frame. Should I just weld some square stock across frame close to the crossmember to brace it? Any tips on removing the rivets?...
Showing results 1 to 9 of 9

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:58 AM.