Forum: Early V8 (1932-53)
01-29-2022, 10:48 AM
|
Replies: 5
Views: 655
Re: Looking for measurements on 32 sedan
Those numbers you gave me were good on mine. I have changed the rocker and it doesn't seem to stick out far enough under the door.
I was wondering if you could measure the flat part of the rocker...
|
Forum: Early V8 (1932-53)
01-27-2022, 12:32 PM
|
Replies: 5
Views: 655
|
Forum: Early V8 (1932-53)
01-27-2022, 12:01 PM
|
Replies: 5
Views: 655
|
Forum: Early V8 (1932-53)
01-27-2022, 10:13 AM
|
Replies: 5
Views: 655
Looking for measurements on 32 sedan
Looking for the measurement between the screw holes at the a pillar that hold the sill plate. That's side to side. Does anyone know of a book with body measurements for the 32 sedan. Thanks
|
Forum: Early V8 (1932-53)
01-16-2021, 07:42 PM
|
Replies: 8
Views: 1,393
|
Forum: Early V8 (1932-53)
01-16-2021, 07:37 PM
|
Replies: 8
Views: 1,393
|
Forum: Early V8 (1932-53)
01-16-2021, 07:33 PM
|
Replies: 8
Views: 1,393
Re: drip edge on 32 sedan
Well i must say i did a fine job getting the drip edge bent. i used a brake rotor. bolted a flat plate to the wheel stud holes then drilled a center hole in the middle of the rotor. took a piece of...
|
Forum: Early V8 (1932-53)
01-14-2021, 09:04 AM
|
Replies: 8
Views: 1,393
Re: drip edge on 32 sedan
using the steel one . funny they bend them for the 5 window but not the sedan. trying to find out the different ways to do it.
|
Forum: Early V8 (1932-53)
01-13-2021, 06:59 PM
|
Replies: 8
Views: 1,393
drip edge on 32 sedan
hi i'm looking for a little help in ideas to bend the drip edge on a 32 sedan. Any suggestions would be helpful thanks
|