Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 405
Search took 0.03 seconds.
Search: Posts Made By: fordscript
Forum: Early V8 (1932-53) 05-19-2021, 03:15 AM
Replies: 59
Views: 2,843
Posted By fordscript
Re: 33 navigator

Lawrie, so sorry to hear of your sad loss, our thoughts are with you.
Forum: Early V8 (1932-53) 12-30-2020, 04:48 PM
Replies: 16
Views: 1,131
Posted By fordscript
Re: 1934 Pressure plate swap

I have a 34 trans case hooked up to a 36 LB with a 35 and later 9" clutch. No issues.
Forum: Early V8 12-11-2020, 02:21 AM
Replies: 0
Views: 372
Posted By fordscript
Gordon

Wanted, Aluminum 21 stud head for 1934-36 V8. Drivers side (L/h), 40-6050-A2, Made in Canada. NOS or excellent used.
Forum: Early V8 (1932-53) 09-29-2020, 02:10 AM
Replies: 15
Views: 1,041
Posted By fordscript
Re: spark plug wire conduit ID?

I believe these were the originals used with the 'crab' type distributor. one plug lead from each side crossed over to the other, and the lead was covered with that rope- like material.
Forum: Early V8 (1932-53) 09-21-2020, 05:35 PM
Replies: 5
Views: 891
Posted By fordscript
Re: Richard Merlini, in Bolder, CO - good seller!

I bought a nos camshaft off him. Great to deal with.
Forum: Early V8 (1932-53) 09-08-2020, 04:32 PM
Replies: 3
Views: 452
Posted By fordscript
Re: Stuck Valve

Make sure that the cam lobe is on the 'heel'. The valve beside the stuck one should also be open. Keep in mind also, that these valves bend very easily.
Forum: Early V8 (1932-53) 09-06-2020, 05:05 PM
Replies: 13
Views: 744
Posted By fordscript
Re: Tires... Radial vs bias

Wow,your 37 coupe looks magnificent.
Forum: Early V8 (1932-53) 08-20-2020, 03:07 AM
Replies: 10
Views: 905
Posted By fordscript
Re: '40 Ford carb fine tuning help needed

I have always found that when you get the idle real 'sweet', it will often hesitate when you give it some gas, so then I richen the idle mixture a little, and it seems to cure the problem. might work...
Forum: Early V8 (1932-53) 08-17-2020, 05:03 AM
Replies: 11
Views: 942
Posted By fordscript
Re: Spring Shackle Pins for a '37 V8 (New Zealand)

These were DUFOR replacements, made in Australia
Forum: Early V8 (1932-53) 05-06-2020, 03:38 AM
Replies: 55
Views: 5,650
Posted By fordscript
Re: Help Me -before I go mad

Sounds like might be the rotor....old originals do go bad, new repros are suspect. 4.3 at the coil is low enough, what is the generator charging? I don't know, but are Skips coils built to be 4.3...
Forum: Early V8 (1932-53) 05-02-2020, 05:07 AM
Replies: 1
Views: 672
Posted By fordscript
exhaust manifold

Having a tidy up, and came across this unusual right hand side exhaust manifold. It appears to be a typical 37-39, but the outlet is 'angled'. Attached pics with a regular 37-39 for comparison....
Forum: Early V8 (1932-53) 08-14-2019, 04:23 AM
Replies: 16
Views: 2,089
Posted By fordscript
Re: I love this!

That there is a 3-wheel chopper
Forum: Early V8 (1932-53) 08-05-2019, 04:40 PM
Replies: 5
Views: 849
Posted By fordscript
Re: 37 ford transmission

Yes, they are all the same.
Forum: Early V8 (1932-53) 08-01-2019, 02:55 AM
Replies: 16
Views: 1,409
Posted By fordscript
Re: 34 ignition lock

Usually the door lock and the ignition lock share the same key. Take the door lock out and get a key to fit that....the code is stamped into the side of the barrel. Might be lucky.
Forum: Early V8 (1932-53) 06-27-2019, 05:56 PM
Replies: 5
Views: 828
Posted By fordscript
Re: 1947 V8 Ford hard starting

Check that the earth strap from the back of the r/h head is connected to the firewall. I have had this problem...engine will crank over fine, but not start.
Forum: Early V8 06-22-2019, 02:39 AM
Replies: 0
Views: 444
Posted By fordscript
rear main bearing shells

I am needing a pair of rear main bearing shells...81A 6331 T. These are .030 u/s with .015 o/s thrusts. Thanks,Gordon
Forum: Early V8 (1932-53) 06-18-2019, 03:56 AM
Replies: 22
Views: 2,924
Posted By fordscript
Re: 39 Coupe Broken Axle Removal.

If you replace a r/h axle with a used axle that came from the left side of another diff, then that axle has been continuously "torqued" in the opposite direction....and it might not like being...
Forum: Early V8 (1932-53) 06-17-2019, 05:46 PM
Replies: 22
Views: 2,924
Posted By fordscript
Re: 39 Coupe Broken Axle Removal.

And if you aren't using a NEW axle, make sure the axle you are using came off the same side
Forum: Early V8 (1932-53) 06-16-2019, 06:19 PM
Replies: 18
Views: 2,675
Posted By fordscript
Re: 1939 Pickup Headlight buckets

They should all have the 'FORD' script on them....front top.
Forum: Early V8 (1932-53) 06-16-2019, 03:41 AM
Replies: 18
Views: 2,675
Posted By fordscript
Re: 1939 Pickup Headlight buckets

35-36-37 pickup headlight buckets were different to 38 -39 which were the same. Trucks were the same as pickups. Lenses, stainless surrounds and reflectors were the same for all these years, as were...
Forum: Early V8 (1932-53) 04-08-2019, 04:22 PM
Replies: 34
Views: 3,543
Posted By fordscript
Re: 35 Steering Column Drop Break-off Bolt Removal

I drill a hole in the centre... a good soak of penetrating oil,then use an ez out.
Forum: Early V8 12-15-2018, 04:14 PM
Replies: 0
Views: 642
Posted By fordscript
Wanted, 37 grille

Wanted, 37 grille in excellent condition, chromed (or chromable), have some 32 parts to trade. rebuilt original 32 distributor and genuine spark plug lead conduits, DL carb parts, original unbroken...
Forum: Early V8 (1932-53) 12-15-2018, 03:58 PM
Replies: 5
Views: 914
Posted By fordscript
Re: carb backfire

Sounds like its running lean....maybe a vacuum leak somewhere?
Forum: Early V8 (1932-53) 11-06-2018, 03:11 AM
Replies: 38
Views: 4,021
Posted By fordscript
Re: Setting the points crab dizzy

sometimes you can fix it by swapping over the moveable parts of the points. Try that before bending anything.
Forum: Early V8 (1932-53) 09-04-2018, 04:01 AM
Replies: 1
Views: 670
Posted By fordscript
38 radio

Do any of you fellows know where I can get a dial plastic for a 38 radio. I am meaning the thin plastic strip, stapled together, with the radio station numbers on it. The one I have is so brittle, it...
Showing results 1 to 25 of 405

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:48 AM.