Forum: Model A (1928-31)
05-17-2022, 12:20 AM
|
Replies: 12
Views: 2,405
Re: rear axle question
Here is what I did - I took my axles to a cam shop, had them build up the seal area and then ground it to the proper diameter. They do that process all the time on cams. The cost was actually...
|
Forum: Model A (1928-31)
08-15-2021, 11:52 PM
|
Replies: 8
Views: 2,018
Re: 1929 water pump packing nut
Just a word about rebuilding water pumps. I purchased one of the leakless water pump bushings from Bratton's. It is a press fit into the water pump housing. However the new bushing was slightly...
|
Forum: Model A (1928-31)
08-15-2021, 09:33 AM
|
Replies: 28
Views: 7,266
|
Forum: Model A (1928-31)
08-15-2021, 12:41 AM
|
Replies: 28
Views: 7,266
|
Forum: Questions & Suggestions
08-15-2021, 12:32 AM
|
Replies: 78
Views: 53,588
|
Forum: Model A (1928-31)
10-23-2019, 12:44 AM
|
Replies: 28
Views: 7,266
Re: 29 Model A Project-Speedster?
I've nearly completed work on the body of my boat tail speedster. Here are a couple of pictures to show you the progress. I posted earlier to this thread. Again I'm, using a Model A frame, engine...
|
Forum: Model A (1928-31)
01-23-2019, 04:47 PM
|
Replies: 28
Views: 7,266
Re: 29 Model A Project-Speedster?
I'm working on a hand built all steel boat tail Model A speedster. The basis is a Model A frame shortened 11 inches to get the proportions correct for the wheel base / body. The body frame is...
|
Forum: Model A (1928-31)
07-26-2017, 10:03 PM
|
Replies: 8
Views: 2,959
|