Forum: Model T (1909-1927)
01-21-2024, 12:47 AM
|
|
Replies: 1
Views: 592
Holley G air and fuel flow diagram
Just wondering if anyone has a reasonably large, hi-res (old eyes!) diagram of the air and fuel flow for the Holley G carburettor?
Many thanks!
John
|
|
Forum: Model T (1909-1927)
01-07-2024, 12:55 AM
|
|
Replies: 3
Views: 423
Holley G issue (again!)
A few weeks ago I removed the Holley G carburettor from my Model T as I wanted to install a stopcock in the fuel line. Prior to this I needed to lock multigrips on the rubber hose to the carburettor....
|
|
Forum: Model T (1909-1927)
01-06-2024, 01:51 PM
|
|
Replies: 2
Views: 473
|
|
Forum: Model T (1909-1927)
01-05-2024, 09:17 PM
|
|
Replies: 2
Views: 473
Holley G Fuel Pickup tube
Just seeking clarification on exactly where the tip of the fuel pickup tube should be when tightening. Is it perpendicular? Or is it slightly off center/centre towards front of engine or rear of...
|
|
Forum: Model T (1909-1927)
12-04-2023, 02:04 AM
|
|
Replies: 2
Views: 601
Engine won't start
...a problem, I think, of my own making.
I recently took off my Carburettor to give it a service, replacing gaskets etc. Was a bit of a challenge as I noted that I had no petcock between the tank...
|
|
Forum: Model T (1909-1927)
07-24-2023, 02:21 PM
|
|
Replies: 6
Views: 1,014
|
|
Forum: Model T (1909-1927)
07-21-2023, 11:30 PM
|
|
Replies: 6
Views: 1,014
Pedal Positioning & Band Adjusting
Whilst I had the engine out replacing the brass bolts in the magneto, I also decided to change over the hogshead on my T to allow for a starter motor to be fitted. That all went well. I am now at the...
|
|
Forum: Model A (1928-31)
07-16-2023, 04:51 PM
|
|
Replies: 2
Views: 421
Brake screech when reversing
Some months ago I installed the Flathead Ted floater kit on my 1928 Phaeton. Just after this I left on holidays and it is just recently that I have gone back to working with my cars.
When I...
|
|
Forum: Model T (1909-1927)
05-03-2023, 01:03 PM
|
|
Replies: 3
Views: 786
|
|
Forum: Model T (1909-1927)
05-03-2023, 12:47 AM
|
|
Replies: 3
Views: 786
Ball Cap query.
Just a query - when fitting the ball cap (T-3369) there is a single hole in the shaft. Where does that align? Hole at the top? At the bottom etc? I just didn't notice when I took it apart.
|
|
Forum: Model T (1909-1927)
02-21-2023, 10:06 PM
|
|
Replies: 2
Views: 618
Notch for Starter Motor
I recall seeing a post somewhere about putting a notch in the Magnetor Backing Plate to enable a starter motor to be fitted. Like the one on the left of the photo at about 9 o'clock. Has anyone done...
|
|
Forum: Model A (1928-31)
01-29-2023, 01:18 AM
|
|
Replies: 12
Views: 1,800
Re: Tight Fit in My 1929 Roadster
I had the same issue with my 1928 Phaeton. When it came time to re-upholster the front seat, I tied some wire between the springs - in effect part compressing them where I sat in the drivers...
|
|
Forum: Model T (1909-1927)
01-13-2023, 03:12 AM
|
|
Replies: 4
Views: 1,462
Rear axle query
I just removed the rear axle bearing and sleeves and am starting to install new parts.
Looking into the axle housing, I note that there appears to be a ring about 5" in. The edges look ragged as...
|
|
Forum: Model A (1928-31)
12-10-2022, 01:31 AM
|
|
Replies: 8
Views: 1,344
Re: Emergency brake pawl question
In the end my issue did not directly relate to either the pawl of the ratchet. I dismantled the handle to give it a clean and realised I had another "farmers fix" Instead of the pivot pin in the...
|
|
Forum: Model A (1928-31)
12-10-2022, 01:09 AM
|
|
Replies: 1
Views: 668
Emergency Brake Rod query
Having sorted my emergency brake ratchet and pawl issue of last week, it seems I cannot take a trick at the moment! In making the adjustment to the emergency brake rod, so that the emergency brake...
|
|
Forum: Model A (1928-31)
12-07-2022, 04:45 AM
|
|
Replies: 8
Views: 1,344
Re: Emergency brake pawl question
John, you are on the money regarding the parts. Whilst the two pawls, old and new are the same size, when you line up the two holes in each (I used bolts/drill bit to hold firmly in place) it is...
|
|
Forum: Model A (1928-31)
12-07-2022, 01:00 AM
|
|
Replies: 8
Views: 1,344
Emergency brake pawl question
Just seeking some suggestions to solve a problem.
I have just replaced the Emergency Brake Handle Lever Ratchet and the Emergency Brake Pawl. My problem is that when I depress the pistol grip,...
|
|
Forum: Model T (1909-1927)
11-27-2022, 05:02 AM
|
|
Replies: 5
Views: 1,128
Re: Magneto suddenly stopped providing current.
Well, I removed the three screws, held down the contact, gently removed my hand - and nothing moved! Looked at the unit, cleaned it up and adjusted the length of the spring. Replaced everything and...
|
|
Forum: Model T (1909-1927)
11-26-2022, 07:57 PM
|
|
Replies: 5
Views: 1,128
Magneto suddenly stopped providing current.
I was out driving in my 1915 Model T a few weekends ago and it suddenly stopped running. I knew the fuel level was low in the tank; I was going up a hill - so I assumed it was a fuel issue. Yesterday...
|
|
Forum: Model A (1928-31)
11-20-2022, 04:30 PM
|
|
Replies: 15
Views: 1,748
|
|
Forum: Model A (1928-31)
11-19-2022, 11:00 PM
|
|
Replies: 15
Views: 1,748
Flywheel / clutch area noise
After I lift my foot off the clutch pedal, there is a loud whining sound. Push the clutch pedal down again and the noise stops. Happens both when in gear and in neutral.
Any initial thoughts?
...
|
|
Forum: Model T (1909-1927)
10-23-2022, 03:01 PM
|
|
Replies: 2
Views: 1,427
Re: Carb Control
Many thanks for the links. From the blueprints I was able to make out where I needed to drill the hole.
|
|
Forum: Model T (1909-1927)
10-21-2022, 01:15 AM
|
|
Replies: 2
Views: 1,427
Carb Control
I realized a few weeks ago that the 1915 Model T that I have owned for the last 15 years did not have a Carb Control. I have one now for my wooden firewall. But a question.
Is there an accurate...
|
|
Forum: Model A (1928-31)
10-08-2022, 05:25 PM
|
|
Replies: 1
Views: 485
Pedal Bushing Replacement RHD
It looks as if it is possible, but I want to ask just to make sure.
On a RHD 1928, can the Brake Pedal bushing be replaced without having to undertake the remove of the transmission etc. It does...
|
|
Forum: Model A (1928-31)
09-14-2022, 02:49 PM
|
|
Replies: 9
Views: 1,247
1928 35A Seat Belts?
Just wondering if anyone has installed seat front seat belts in a 1928 Phaeton (35A)? I am considering doing so, but with the bench seat I can see issues around placement, bolt head clearance etc....
|
