Forum: Model A (1928-31)
02-18-2021, 10:35 PM
|
|
Replies: 17
Views: 693
|
|
Forum: Model A (1928-31)
02-02-2021, 08:12 PM
|
|
Replies: 36
Views: 2,408
|
|
Forum: Model A (1928-31)
01-31-2021, 09:09 PM
|
|
Replies: 18
Views: 1,701
|
|
Forum: Model A (1928-31)
01-24-2021, 04:46 PM
|
|
Replies: 24
Views: 1,064
Re: Popping carb
How is the valve lash ? One valve too tight could cause the condition.
|
|
Forum: Model A (1928-31)
01-16-2021, 10:24 PM
|
|
Replies: 34
Views: 2,272
Re: Help with an engine noise...
Tom,
Thanks for the follow up. Might check the U joint while it is apart and change it out if there is any play. Let us know when you are back together and running. Would like to know exactly how...
|
|
Forum: Model A (1928-31)
01-15-2021, 10:01 PM
|
|
Replies: 20
Views: 775
|
|
Forum: Model A (1928-31)
01-15-2021, 09:54 PM
|
|
Replies: 24
Views: 1,272
Re: Benefits of a thermostat?
Not a big deal during the summer. In cold weather when an engine never warms to normal operating temperature it tends to run rich which results in higher fuel consumption. A more significant issue...
|
|
Forum: Model A (1928-31)
01-14-2021, 03:25 PM
|
|
Replies: 35
Views: 2,855
Re: Adding Guages
It wouid be worthwhile to at least have an idiot light for oil pressure (IMHO). Another scenario to the ones you cited would be engine oil level is very low or crankcase is empty. The engine would...
|
|
Forum: Model A (1928-31)
01-10-2021, 06:50 PM
|
|
Replies: 13
Views: 755
Re: Replacing king pins
https://www.youtube.com/watch?v=tKj5xRwAHfY&list=PLav-W1BC-Nj9S3vEOoqgvqn60A_JPvFda&index=1
|
|
Forum: Model A (1928-31)
01-09-2021, 07:39 PM
|
|
Replies: 42
Views: 2,509
|
|
Forum: Model A (1928-31)
01-09-2021, 07:34 PM
|
|
Replies: 13
Views: 682
|
|
Forum: Model A (1928-31)
01-09-2021, 07:33 PM
|
|
Replies: 25
Views: 928
Re: King pin replace
Concur with Bill. I would prefer to buy special tools and try and do the job rather than farm it out. Experience is a great teacher. Just my $.02.
|
|
Forum: Model A (1928-31)
01-09-2021, 07:30 PM
|
|
Replies: 21
Views: 1,278
Re: Reducing Steering Free Play
Might also ensure the Pittman arm is solidly clamped to the sector shaft. Look at the connection closely while rocking the steering wheel. Even a minute amount of looseness will result in...
|
|
Forum: Model A (1928-31)
01-08-2021, 03:54 PM
|
|
Replies: 25
Views: 928
Re: King pin replace
Yes, did it. Be sure to replace the bushings in a sequence. After pressing in one new bushing, run the reamer through the old bushing into the new bushing so the bore is centered. After pressing...
|
|
Forum: Model A (1928-31)
01-05-2021, 08:26 PM
|
|
Replies: 28
Views: 1,008
Re: Where do I go from here??
All good advise. Welcome to the hobby. Expect people to wave when you are driving around. Be sure to reward them with a well tuned AH OO GA !!
|
|
Forum: Model A (1928-31)
01-05-2021, 05:16 PM
|
|
Replies: 13
Views: 581
Re: Cause of Blow By
A first step would be a compression check to assess ring performance. Maybe try some Seafoam if case the rings are just stuck. Let us know how it goes.
|
|
Forum: Model A (1928-31)
01-04-2021, 04:35 PM
|
|
Replies: 7
Views: 487
|
|
Forum: Model A (1928-31)
01-04-2021, 04:32 PM
|
|
Replies: 10
Views: 526
|
|
Forum: Model A (1928-31)
01-01-2021, 12:44 PM
|
|
Replies: 8
Views: 757
Re: 31 Universal Joint is it original or repro
Either original or a very good repro. More likely domestic rather than off shore. Also the more desirable spider type rather than the riveted variety. If no rotational play it would be a good...
|
|
Forum: Model A (1928-31)
12-30-2020, 08:22 PM
|
|
Replies: 75
Views: 3,387
Re: Old sayings
Must be 70+ to really appreciate this one.
"Life is like a roll of toilet paper - the less you have, the faster it goes".
|
|
Forum: Model A (1928-31)
12-26-2020, 09:58 PM
|
|
Replies: 44
Views: 2,293
Re: Troubleshooting advice
Sticking valves is a high probability. Recommend dripping Marvel Mystery Oil directly into the carb intake at elevated rpm and also puting MMO in the fuel tank (4 oz. for full tank).
|
|
Forum: Model A (1928-31)
12-24-2020, 11:04 PM
|
|
Replies: 63
Views: 4,424
Re: Signs, back in the day
Use to be a sign in the Pentagon photo lab which said "If you want a better picture, bring a better face".
|
|
Forum: Model A (1928-31)
12-24-2020, 11:01 PM
|
|
Replies: 63
Views: 4,424
|
|
Forum: Model A (1928-31)
12-21-2020, 08:28 AM
|
|
Replies: 7
Views: 801
|
|
Forum: Model A (1928-31)
12-19-2020, 03:22 PM
|
|
Replies: 13
Views: 1,342
Re: 2-3 Shift Point Speed
Problem solved. Turns out I was not using enough advance. Typically I start full up on the timing lever and drop down to 1/3 to drive. Tried 7/8 to full advance and it runs fine at 20 mpg. At...
|
