Forum: Model A (1928-31)
01-17-2020, 11:28 PM
|
|
Replies: 17
Views: 2,699
|
|
Forum: Model A (1928-31)
12-05-2019, 11:38 PM
|
|
Replies: 17
Views: 2,699
|
|
Forum: Model A (1928-31)
12-03-2019, 11:51 PM
|
|
Replies: 17
Views: 2,699
|
|
Forum: Model A (1928-31)
10-04-2015, 11:51 AM
|
|
Replies: 9
Views: 3,853
Re: Vent for Model A upper floorboard
I have a set-up like this for my 28 4dr ,funnel shaped close to radiator then flexed back under floor, housing over muffler for heat then outlets flexed to front and back seat with units same as...
|
|
Forum: Model A (1928-31)
04-09-2015, 12:05 AM
|
|
Replies: 12
Views: 2,578
|
|
Forum: Model A (1928-31)
11-03-2014, 12:42 AM
|
|
Replies: 8
Views: 2,175
Re: Heater
All I want to know is it worth cleaning up and installing ,floor cut in the back seat
for vent. Is any one familiar with this unit?
|
|
Forum: Model A (1928-31)
11-02-2014, 07:41 PM
|
|
Replies: 8
Views: 2,175
Heater
What kind of heater is this?
|
|
Forum: Model A (1928-31)
10-28-2014, 03:55 PM
|
|
Replies: 8
Views: 1,980
1928 brake service shaft
Would it be safer to change out my 3 piece brake service shaft to the 1 piece ? I was pushing hard on brake pedal and center ball came out, pedal to floor no brakes! It was a ford change over from 3...
|
|
Forum: Model A (1928-31)
10-17-2014, 02:48 PM
|
|
Replies: 46
Views: 14,765
Re: Manifold heater is ugly
When I got my 28 4dr LB in one of the box of parts was a heater that covers the muffler ,also flex pipe to front and back seat with registers cut in the floor to regulate air flow , who was the...
|
|
Forum: Model A (1928-31)
09-25-2014, 08:10 PM
|
|
Replies: 8
Views: 2,360
|
|
Forum: Model A (1928-31)
09-25-2014, 05:27 PM
|
|
Replies: 8
Views: 2,360
Re: powerhouse gen test?
tried the cardboard and sanded the comutators from less than 2volt tested with a drill motor up two about 6 where do you get the brushes 5 brush gen
|
|
Forum: Model A (1928-31)
09-24-2014, 05:25 PM
|
|
Replies: 8
Views: 2,360
powerhouse gen test?
My powerhouse gen. will motor ,fast idle flutters from 18 volt to 4 volt ammeter does not register..Is their trouble shooting steps?
|
|
Forum: Model A (1928-31)
09-13-2014, 03:29 PM
|
|
Replies: 4
Views: 1,631
7 tooth steering box leak
I got this 1928 leather back from my inlays, in the family since new . A bunch of people worked on it through the years and when it trailer into my place had several boxes and cans of parts . Put the...
|
|
Forum: Model A (1928-31)
08-19-2014, 03:58 PM
|
|
Replies: 9
Views: 2,316
Re: motor mount
look's like I will leave it stock.The A been in the inlays family since new,setting since 1972.
|
|
Forum: Model A (1928-31)
08-19-2014, 12:53 PM
|
|
Replies: 9
Views: 2,316
motor mount
Finally towed the 1928 leatherback out of the hills and into the garage,the front motor mount is direct to the frame. With the A ,was a book about 1928 A only and it said to change the mount to the...
|
|
Forum: Model A (1928-31)
06-03-2014, 01:01 AM
|
|
Replies: 1
Views: 1,584
A club
Is there model A club close to Ocean Shores WA?
|
|
Forum: Model A (1928-31)
05-31-2014, 11:12 PM
|
|
Replies: 18
Views: 4,567
Re: 1928 fordoor clutch type
Just got back from looking at my new leatherback ,sat in garage in hills for 40 years .No rust, boxes of old and new parts ,5 new tires and tubes, bad some one of family started to restore.Have to...
|
|
Forum: Model A (1928-31)
05-30-2014, 09:01 PM
|
|
Replies: 18
Views: 4,567
|
|
Forum: Model A (1928-31)
05-28-2014, 01:16 PM
|
|
Replies: 18
Views: 4,567
1928 fordoor clutch type
My daughter-in--law is giving me her mom's A and I heard that year had two different clutch types and one is not replaceable.
|
|
Forum: Model A (1928-31)
05-25-2014, 04:50 PM
|
|
Replies: 3
Views: 1,437
gas tank
Do I have to pull the gas tank on 1928 leatherback to clean and seal it?
|
