Forum: Early V8 (1932-53)
10-30-2023, 09:51 AM
|
Replies: 13
Views: 941
|
Forum: Early V8 (1932-53)
10-30-2023, 09:42 AM
|
Replies: 13
Views: 941
|
Forum: Early V8 (1932-53)
09-21-2023, 06:07 PM
|
Replies: 47
Views: 2,718
|
Forum: Early V8 (1932-53)
05-25-2023, 10:50 AM
|
Replies: 24
Views: 1,814
Nice 34 Roadster
https://barnfinds.com/1st-place-award-winner-1934-ford-roadster/
|
Forum: Early V8 (1932-53)
03-04-2023, 11:13 AM
|
Replies: 23
Views: 5,943
|
Forum: Early V8 (1932-53)
06-24-2022, 01:36 PM
|
Replies: 14
Views: 1,231
Re: 1932 Ford rear brake drum questions
Use J&G Brake Drum Relining & Refurbishing www.jgrelining.com/ they will reline & refurbished your original brake drums and also re-arc your brake shoes to the drum.
|
Forum: Early V8 (1932-53)
05-25-2022, 10:07 PM
|
Replies: 6
Views: 926
1934 Fuel Line
Who makes a good reproduction 1934 fuel line this is the short rubber fuel line between the fuel pump and the main gas line? The one I have is only 5 years old and it is all cracked and just started...
|
Forum: Early V8 (1932-53)
12-04-2021, 11:28 AM
|
Replies: 2
Views: 926
|
Forum: Early V8 (1932-53)
08-03-2021, 03:26 PM
|
Replies: 12
Views: 1,415
Re: 34 Coil Carbon Brush
Terry, I removed the rebuilt Bubba's distributor and the mechanical advance weights were not stuck but when I compared the tension on the vacuum brake piston compared to my original distributor it...
|
Forum: Early V8 (1932-53)
08-02-2021, 03:51 PM
|
Replies: 12
Views: 1,415
Re: 34 Coil Carbon Brush
Yes but Bubba set up the rebuilt distributor that i just installed yesterday and he would have had that all set up!
|
Forum: Early V8 (1932-53)
08-02-2021, 10:14 AM
|
Replies: 12
Views: 1,415
Re: 34 Coil Carbon Brush
Terry, I have already installed a new brush into the coil. I just cant figure out way I dont have any acceleration.
|
Forum: Early V8 (1932-53)
08-02-2021, 09:54 AM
|
Replies: 12
Views: 1,415
34 Coil Carbon Brush
Yesterday I took my 34 out for a drive and it ran great until I stopped. About 20 minutes later I started it to drive home and I could only accelerate to about 35 mph with the engine stumbling. The...
|
Forum: Early V8 (1932-53)
06-24-2021, 04:38 PM
|
Replies: 5
Views: 715
|
Forum: Early V8 (1932-53)
03-26-2021, 04:31 PM
|
Replies: 11
Views: 1,954
|
Forum: Early V8 (1932-53)
03-09-2021, 05:58 PM
|
Replies: 46
Views: 5,151
|
Forum: Early V8 (1932-53)
02-23-2020, 02:59 PM
|
Replies: 9
Views: 1,354
|
Forum: Early V8 (1932-53)
02-23-2020, 01:40 PM
|
Replies: 9
Views: 1,354
|
Forum: Early V8 (1932-53)
02-23-2020, 01:15 PM
|
Replies: 9
Views: 1,354
Re: 1934 ford tack strip
I used hard leather belting I installed the top 3 years ago and the tacks have held with no problems.
|
Forum: Early V8 (1932-53)
07-16-2019, 10:12 AM
|
Replies: 10
Views: 2,312
|
Forum: Early V8 (1932-53)
07-16-2019, 10:02 AM
|
Replies: 15
Views: 2,373
Re: Rattle - Help!
Before I re-restored my 34 roadster I had the same problem and it was the muffler hitting the frame.
|
Forum: Early V8 (1932-53)
06-21-2019, 11:55 AM
|
Replies: 13
Views: 1,897
Re: Side Anti Rattle bumper on a 34 Rumble lid
Here is a picture of the sheet metal retainer/dam which contains the water and drains out the holes in the rear of the floor pan. Unfortunately you cant see the drain holes in the picture but they...
|
Forum: Early V8 (1932-53)
06-19-2019, 01:41 PM
|
Replies: 13
Views: 1,897
|
Forum: Early V8 (1932-53)
06-19-2019, 11:17 AM
|
Replies: 13
Views: 1,897
|
Forum: Early V8 (1932-53)
04-19-2019, 09:56 AM
|
Replies: 104
Views: 20,449
Re: Roy Nacewicz
RIP Roy I only wish that RIP meant "Return if Possible" How lucky I am to have known you the guidance that you gave me on the bolting requirements for my 34 roadster during its restoration was so...
|
Forum: Early V8 (1932-53)
03-19-2019, 09:16 PM
|
Replies: 42
Views: 10,871
|